© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Does anybody know a source for a small 4-5" "question mark" shaped fuel tube/pipe; bayonet fittings that runs between the Bosch fuel pump and the...
I have been advised to use simple Prestone. Opinions? Before you quote the manual, I have the manual but I do not intend to order Italian...
Or, could it just be atmospheric pressure relief? I discounted that as I am used to the Mercedes, Citroen and Maserati old hydropneumatic...
My 1985 400i kit came with two new Bosch fuel pressure accumulators. I have long since installed them but I have an open issue. Besides the two...
Pipe arrived today from - Italy.... Moderately painful to install. It was not a precision manufacturing job. Shocking, I know. It is held in...
thanks! Also for the hint about purging the system.
Thanks! I am in pursuit of tube part 110685!
Outstanding! thanks again. I will order the pipe today. Here the sensors and throttle are pulled for better access. I wish they had added...
[ATTACH]
It is also know as the REFLUX pipes 114960. Where do they go, please?
1985 Ferrari 400i fuel system question: The (new) 113978 Bosch fuel accumulators had their return lines missing from the little 90 degree tubes in...
Does anyone know the part number for what appears to be a missing brass fitting that connects this hose from the oil separator to the block (small...
WOW! Hand-painted from the factory?????? : )
This was EXTREMELY helpful. THANK YOU. I am missing that 100453 temperature switch on the back that is showing in your picture. I have ordered...
Correct. Oil pressure
I would be very grateful for a copy, too.
[ATTACH] [ATTACH] The green wire with the spade connector and the frayed boot is the one in question. The kickdown switch has not been...
So, I am putting a 400i back together. The engine was rebuilt. A previous mechanic lost half the plumbing parts and died.... I am the new owner. I...
thanks in advance for your inputs
So, I am putting a 400i back together. Engine was rebuilt. Mechanic lost half the plumbing parts and died.... I am connecting the "green" sensor...