© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I like the non-original mirrors which I'm sure are a lot more useful than the factory ones on my 76 GTB. Do you know where they were sourced or...
Thank you to all who responded. I now have plenty of choices.
I'm reasonably sure the 76-77 interiors are the same, so if you find that you have it, let me know--and thank you.
The closing snap button (#60094604) on my fuse panel cover (lower left hand corner) is missing and most of our sponsor sites list it as NOT...
Yep, rare stuff it seems. I was told that many of the TRACTOR SUPPLY stores carry it but not so in my neck of the woods--Boulder CO. Amazon will...
It was recommended to me to use Shell Rotella ELC NF coolant/antifreeze in my '76 308 but I have not been able to locate any locally. Only the...
What's a "hydraulic bridge jack"? Can you post a picture? I'm certain I need one to raise the rr wheel for many of the services on my 308.
My '76 308 GTB has a brass drain plug incorporating a magnet--doubtless a non-original part. I would like to replace it with a similar new one but...
After cutting open the oil filter, looking through the drain hole with a tiny mirror and boroscope (useless), and through the top-side oil fill...
Thank you all for your recommendations and advice. I always look forward for help from those 308 owners who, like me, try to do as much as...
Any other hints or tips for removing, cleaning and then replacing the pan? Other than the pan gasket, is there anything else I should order before...
Steve, thanks for the tip. I'll go ahead and order a green gasket (#104 197) from Daniel at Ricambi in the morning.
Can the engine oil sump aluminum pan (part #104192) be removed by simply taking off the 14 nuts and washers that appear to bolt it to the engine...
Thank you both for replying. And, no, Steve, it's not a trick question--I apologize if it sounded that way. I just wanted to make sure that the...
The NAPA # 704 1356 copper washer is a perfect fit for the early (carbureted) 308 gearbox drain plug. Is there a corresponding copper washer for...
All of my toy cars (M-B, XKE, Corvettes) are 60's-70's vintage and they've been run on Rotella 15W40 for many years without any ill effects, on...
Thank you very much
done
No, I have not found it nor a current source.
No fighting please--LOL--and limit your opinion to these two oils specifically: Shell Rotella 15W40 vs. Valvoline VR1 10W30 Racing. Engine was...
