© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I hope this helps someone else in a "sticky" situation ... My 87 Mondial 3.2 had been sitting under protective covers in the garage for about 3...
Hi Ross, I'll keep my eye out for you! I'm in the south (the Shire!!) and apart from heading out on long trips every now & then, I do the...
The nuts will be normal RH thread. Trick is how to break the taper of the rod-end "shaft" which passes through the hole in the hub. Just...
Tone, driving around Sydney I get about 18 litres per 100 km, dropping to say 12-13 on a run outside the city. If you punt it pretty hard in town...
If you can get it jacked-up onto stands you can try disconnecting the shifter rod where it comes out of the back of the console tunnel, just in...
You may not be getting full disengagement. The 25mm bore 147 cylinder will give you approx 50% less clutch pressure but will require 50% more...
There are 3 bolts, not 2. Then tap to loosen. It needs to be rolled around a bit to get it to pass out above the chassis rail, but it does fit.
ditto (I also need to know). Actually I wish mine was DIMMER, as the damn numbers are *way* too bright. At night any car following you can see...
Thanks to everyone for the comments. Strangely, no-one has yet mentioned our local F-dealer - does *anyone* use Italia Motori? I had assumed that...
Maaaates! Well I just strolled 'round the corner & BUGGER ME if there ain't an Oz forum here! I guess I'm a right dill for not scrolling down...
robbio, Someone looks to have nicked the "Quattro..." bit of the badging - no models came with just "Mondial" as far as I know. Also re the...
Dave an old sports car would do me fine! Some of my faves include old Cooper Minis, non-turbo Lotuses, RS Escorts, Alfas, etc. Damn, MOST of...
I'm happy enough with the performance, it's more the nature of HOW the engine delivers it. That's what struck me about the F430 on TG - not it's...
Slack or bad park position - just pull-back the spring-cap on the base & undo the nut. (Pull the blades up b4 doing this, as the base will tend...
Just seen a re-run of the Top Gear F430 episode, and it brought back to me just how UNWILLING my own Mondi 3.2 's engine has always been. Sure...
Coming in a bit late, but anyway ... 1. Re tightening torque, 18ft-lb is pretty light. It's 18 lbs on the end of a 1- foot socket bar, or 2...
If you're using Microsoft Outlook in a corporate environment, you should be able to click on the Deleted Items folder, and (if the item isn't...
First determine if there is excessive free-play in the steering linkage. If you can turn the steering wheel rim by more than say 1cm (1/2")...
Great info. Thanks So anyone know what goes on inside the box? Does it have a separate ODO link to the gearbox, or is all electronic taking...
Ah, where IS this small button exactly? I had assumed (wrongly) the light was reset via the electronic diagnostic plug in the engine-bay (ie:...