© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
disconnect pwr lead to clock k huge drain like 10 amps as i recall worked for me when car was stored for weeks good luck jon s
its such a pita that the compressor is now a permanent resident in the basement. best of all, i now have no excuse not to do the belts when i know...
thanks guys next dry day i'll pull the mtr connectors and yes ur right the motor windings look like a dead short to the ohmmeter. so much for...
fuse is for the headlamp mtrs which stoped working this year. load side of fuse is a short to ground. i was hoping someone had already solved this...
you are welcome. i could never have maintained my 308 at home without this forum and i've always appreciated the help-least i can do. stupid to...
socket just came back from a clutch job in canada. if you need one just send me a pm. usual strict loan agreement. i'll mail it to you and the...
steve : i think you must be right
thanks guys i enjoyed your replies. tom: i put an electromotive ignition in my 81 gtsi and changed the timing way away from stock maybe that...
i'm always impressed by how much grunt the 308 develops at low rpm and relatively high gears. for what was a high rev engine in its day- not known...
you know guys ferrari has already done their belt failure analysis since they had to replace all blown engines on warranty. when a belt will fail...
napa makes a repair kit for rubber trim and bumpers - did a great repair on mine. and i used black rubber spray paint. try it the results are...
how hard was it to find a flat crank electric motor?
replaced the wire in my cables with solid stainless leader wire(big game fishing). worked great and every time i use the car i move the heater...
i also didn't want to take the filter housing off and discovered you can remove and tighten the sender with vice grips on the case- its strong...
albert: make sure the the steering column u joints are tight- tightening the lock screws fixed the rattle in the front end whenever i hit a road...
also, have started using stabil for fuel storage in the injectors and plumbing - hence no pump out. i put fresh gasoline in after putting the...
bell: plumbing stores here sell pure corrosion inhibitor for hot water heating systems that use polypropylene glycol for freeze protection - a...
save your money and use the ground strap connector up front. how many casual thieves know it exists? is there any real flat bed protection?...
friend of mine once had a kid in an oregon gas station ask him what kind of mustang he had. i guess a horse is a horse. cheers, jon s
