© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks! That's what I expected (same as the speedo), however for some reason, it was much tighter and took some serious pulling to get it off....
Hi everyone: I am in the middle of repairing the tach driver with a new Veglia Tacho PCB from dynoplex.org. I got everything out fine, except...
[ATTACH]
And could not resist to buy these wheels... We are getting there, slowly, but surely... [ATTACH]
Ready to go to exhaust mounting next week... [ATTACH] [ATTACH] [ATTACH]
Detail on the throttle bodies and adapters - from 3D prints (left bank) to Aluminum (right) [ATTACH] [ATTACH]
Old camshafts vs. New camshafts... [ATTACH] Engine timing porn [ATTACH] And engine done [ATTACH] [ATTACH]
Hi all, Again time flies and I only find some time now to post on the progress. First the engine assembly after full rebuild have been going...
And installed all new carpets / seats / dashboard / rear shelves / door panels: [ATTACH] [ATTACH] [ATTACH] [ATTACH] Now working on the engine,...
Insulated the cockpit: [ATTACH] [ATTACH] Again did some 3D printing work: [ATTACH] [ATTACH]
Took care of the front compartment & trunk (including custom made antenna base): [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Hi everyone, Update long overdue as usual. There's been much progress with the build. The car is out of body repair and painting, loooking...
Thanks for sharing the numbers! It's always interesting to have open comparisons between builds. Mark, your build is one of a kind, in a...
Thank you for sharing your thoughts and analysis! Indeed, we will not touch either exhaust or intake ports / valves diameters. As you mention, my...
Thanks for the offer, but we are purposely keeping stock valve diameters. This might be controversial, but from what I understand, increasing CFM...
I could only print half of the model, but because the 2 twin bodies will be separated, this is fine to test proper design. Pretty happy with the...
And finally the injection. To get the best out of this engine I have to get rid of the K-Jetronic mechanical injection to install EFI. Following...
Regarding the interior, this is also in progress. All carpets and leather are being re-done. This is where I feel lukcy, I live a few miles away...
Regarding bodywork, the car is being stripped, body defects corrected and will be repainted as original FER 300/6 rosso corsa. Of course the...
Hi guys, Time for an overdue update! I am checking the site regularly but I am poor at reporting progress... The rebuild is making good...
