© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Mystery has been solved. Smiths oil temperature sending unit was installed in place of the correct sending unit intended for the Lucas injection....
I am trying to configure the wiring for the Lucas fuel injection and can't seem to find where where the oil pressure switch fits into the engine...
Is there sufficient space to install dual Lockheed servos to replace the original Girling Mk2A's and still mount them at the angle specified, or...
Good idea! I will have an automotive electrical specialist take a look at it. [ATTACH] [ATTACH]
Many thanks for your suggestion. I believe I may be able to solder a connection on the red wire, but the strands on the black wire are way too...
The wiring on the rear of the electro-magnetic clutch on my water pump has completely disintegrated. Is any repair possible or is there any...
Sincere thanks for your reply. I agree the slack must be removed from the drive side of the chain, requiring any movement of the crankshaft to...
I urgently request help in determining the correct tension for my 4-liter Mistral timing chain. Measured from the edge of the cam cover to the...
I have just finished an overhaul of the cylinder head on my 4-liter Mistral engine including replacement of the valves, valve springs and timing...
The polyurethane coil spring isolator set made by Energy Suspension (9.6101G) appears to be perfect fit on my Mistral springs and only adds about...
Hello Mike, I measured the top of my coil spring housing and the dimensions of the coil and the best generic spring isolator seemed be the one...
Brilliant! Found a perfect fit insulator that matches my springs nearly perfectly. Many thanks for a great suggestion.
Thanks, Mark. I appreciate your effort and especially for letting me know about Cicognani in Italy. I can assume if they don't list it, it's not...
I am preparing to reassemble the front suspension on my Mistral and see a reference in the parts manual to a rubber buffer at the top of the coil...
Thanks to Ivan, again. Fulcrum shaft was removed with no problems and front suspension rebuild can continue on my Mistral.
Hi Mike, Yes, I remember selling you some parts. Good hearing from you. I have a '65 Mistral (109422) with a 4-liter engine (#902) that replaced...
Thanks to all for helping me find this set screw. After stripping the paint off, I finally located this set screw as shown in the photo....
Thanks, Julian. As you noted, the two front suspension designs are identical. I'm still unable however to find the illusive set screw, which I'm...
Wonderful! Many thanks, Ivan
I need help removing the fulcrum shaft from my '65 Maserati Mistral in order to replace the lower control arm bushings. The coil spring has been...
