© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I bought this set up: https://gtcp.com/product/115776rrk-a-c-compressor-retrofit-kit-with-brackets/ Not cheap ($1200-$1300 IIRC?), but they've...
Lol, thanks.
Car is an '87 328 GTB. Slowly getting there on the rebuild and I'm now getting ready to replace all the plastic fuel lines that connect to the...
Damn. Those connections and those ohm readings look fine. So much for the easy win. This thread is starting to live rent-free in my head (" ......
And here's a pic. The yellow tape arrows point to the approximate locations where the two sensors are mounted. And note the harness connections. I...
I have a 1987 328 GTB, so I'm pretty sure you and I have the same motor. There are two sensors. Both are mounted in the bell housing. If you were...
Fooock!! I can't imagine how frustrated you are. Been there, done that and I'm dreading being there again in a few months when I try my first...
Very happy with recent progress. I tried to figure out how to get all-new material for the rear bulkhead covering, but I finally gave up....
Gotcha, so if I'm reading this right, I'll need to put adequate sealant into the big gaps at the top & bottom of the aluminum window frame that...
I'm in the process of re-installing the rear triangular windows in my 1987 GTB. When I test-fit the window assembly, there's this large gap...
Yes, the SP part seems very high quality, and at least as solid as the original part that was in my car. After fully bleeding the system, the...
Thank you for the kind words. On the Bosch stuff, yeah, I'd wised up to this on my previous BMW projects. Searching by the Bosch PN usually cuts...
Thank you! Every time I'd researched this in the past, there's an old F-chat post about these undercoatings where the concensus seems to be...
I also spent a few days recovering all the headliner & rear parcel shelf bits in the correct black-and-gray wool cloth. The main issue here was...
All four calipers were rebuilt with fresh seals & boots. The calipers themselves were replaced in yellow zinc. [ATTACH] Intake plenum was...
Much progress ... Since the last post, I've dug a bunch into the motor to get it resealed. Among other items, I've now replaced all the valve...
Edit: Forgive me, I have 328 on the brain. I confess that if the 308 materials are different, then you can ignore the info below, though you might...
I'm in need of a handful of these white plastic zip-ties. Some time ago, I managed to find a thread here at FC that gave links to these ties at...
This makes a lot of sense, and visually, my old seal carriers do in fact appear to have inserts. I've tried gently removing them, but no luck. And...
Ugh, went down the rabbit hole and now I'm even more puzzled. Service Bulletin 10-18 addresses this seal & carrier issue directly (starting at...
