© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks for all your comments and help so far . I also briefly run the engine to help the gasket varnish dry seal this method always worked well...
Hi All,I’m taking the engine out for a major service and will do the valve guides + valves while it’s out can anyone tell me what’s the best...
very interesting I really liked your article on the cat ECU diagnostic device that you designed and made it was a great help well done :-) to...
Great stuff a useful diagnostic tool thanks for the link :-)
Hi Qavion, thanks for helping me again the wire diags are fantastic thank you :-) . I am fitting my own EGT Amplifiers my car started having some...
That’s great thank you for your time & quick reply , so I only need to use 3 pins for power and temp feedback do you know what the first pin on...
The 355 2.7 motronic ECU needs to see a 0-5 volt signal from the Cat ECU (amplifier) to determine the cat over temp condition ,I’m trying to find...
Hi Qavion, Sorry for delay in my reply I removed the steering column covers and inspected the Block connectors from the ign switch when I pulled...
I had the original Ferrari thrust bearing in mine it’s a 1994 f355 when I did the engine out service I noticed that the pressed steel bearing...
Hi Qavion, That's a big help thank you for taking the time no wonder I couldn't find a starter relay in the wire diags which have a strange...
Hi All, I need to know where to find the location of the starter motor relay can’t find anything in the workshop manual just wanted to know before...
Hi Taz355, My car has done 45k Miles it’s just run in !
That’s correct on this set up when the clutch is operated the slave cyl pushes the clutch/flywheel assembly towards the rear of the car All the...
Hi ago car nut, I don’t believe the thrust bearings are an issue on this crank set up it’s just general wear and tear the thrust bearings are ok...
Hi Wade, As I thought thank you for confirming this for me kind of you to take the time to help Best wishes, Fabio.
Hi Everyone, I am currently replacing the Aux timing pulley gear bearings the sump pan is removed and thought it a good time to replace the crank...
I have a fault with the HVAC system ECU the fan comes on full with hi heat it started doing it just a couple of times last year but now it's on...
I have problems with the AC heater ECU fan comes on full with full heat I am rebuilding the ECU and replacing the bad TCA2465G power amp chips...