© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
It still has to have water to cool both coolers so i assume the water flow is in series
If the tell tails are dry, the pump is probably fine. They drain the void space between the water and oil side ( assuming they are not blocked up)...
Could well be, the diagram is not great
Engine oil cooler is big money, £3800+ vat, yet gearbox about £330+vat. From what i can make out the gearbox one is ontop of the engine oil cooler...
No, you pull the gearbox out as a unit but you have to take the back of the car to bits, about 10 hours labour when they changed my release...
This is the same bearing I changed my oem bearing for, they transferred over the screw bit but they also renewed the roll pin, item 52. Tech was...
On the 430 the power steering oil is a lower quality than the f1 system, so I just put the f1 oil in the steering system. Besides which the OEM...
Plate 0024 item 47. Pt no 206075. Does that clutch sensor have anything to with the issue, if that is giving wrong clutch position??
The clutch sensor you refer too, is this the one that picks up the position of the clutch release bearing ?
If you drop the tray off under the engine you will see the combined oil /water pump. Look for 3 tell tail holes about 4 mm diameter, these should...
Odd this has occurred just after a clutch change !!
If it does that, knock it off and then turn key on and wait until you get the ok message. If on starting you get an e diff or gearbox warning (...
First off are you talking about the steering rack swivel ends, these are available as oem from Ferrari but are plated steel and fail regularly ,...
A good 458 spider is the way to go, great sound from idle, all the way to the red line
Ok he had a faulty coil but why did it fail just on right handers ? Weird !!
STP do an engine oil flush additive, run the car to get the oil hot, then add the STP and fast idle for 10/15 minutes. Knock engine off and drain...
It sounds like the throttle body is sticking, needs cleaning out with specialist throttle body spray for a start. Look for carbon inside
The lamps on a 430 are made by Osram, so i would think they supply the ballast
If it was shorted, does it cure the problem ?
The clutch release bearing is fitted with a sensor, this has a tiny roll pin to fix the sensor lever to the bearing, if that has failed, would...