© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
At the high RPM/Load system goes into the "open loop" mode, assuming this, the lambda readings you see are probably preset ones. It would help to...
That "waviness" applies to an actual deck with liners removed. From what I see on the pictures you shouldn't have any issues.
To properly measure the liner protrusion, you need to clamp them down with the special fixtures and use a dial indicator. Like I mentioned...
Material is an aluminum alloy with Nikasil coating.
The inner diameter of the sleeve is not covered by the head gasket and exposed to a different thermal and chemical processes. I would say it's a...
No, this is not normal, the top of the sleeve has to be square. Ideally, you'll need to replace them. However, if you'll lay a head gasket over...
This is common, cylinder sleeves are protruding above the engine block, an old HG is leaving an imprint on them, no sealant needed. I can show you...
Would you know an approximate date the engine work was done on?
