© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Hi last year I put a new clutch in, aswell as a seal overhaul as I had a leak coming from the inspection plate part numbers 137249 seal ring...
Hi Unfortunately I’ve lost a nut of some description from one of the bracket plates on the roof operation on my 5.2 355. I have the bolt, top...
The issue was the refurbed plate, although it was a little thicker than the 8.3mm, the issue was the actual circumference, they rectified that and...
No I have a manual. After we searching online for the oem thickness i found a post relating to the f1 being 8.9mm thick, so is the manual the...
Thanks very much for the photos, great help. Removed the clutch again today, as suggested I suspect the refurb is too thick, will start the...
Ok thanks
I’ve had the friction place refurbed, as I was told the pressure plate was ok, put it all together today and bled the system however the clutch...
Sorry I meant friction plate
Is it possible to put the clutch pressure plate in backwards?
Hi what I meant was, is there a limit in which the dipstick will show as over filled i.e will the stick show the same line when There’s A) 1...
So for future reference, once the oil drops, how long does it usually take for the oil level to return to its level once the engine is restarted
does the max have a limit on the dipstick? i.e would it still show the same level if you were 2 litres over and 3 litres over?
I checked the level a minute after switching the engine off
Roughly how many litres over full would you say this is? [ATTACH]
1996 355 spider LHD 5.2 Sorry should have been more clear The Tubi exhaust was fitted by a previous owner, I realised no lights came on when...
It’s actually 200 miles I’ve done not 100, I’ve had the car back since yesterday. I’ve had a drive out for a couple of hours again today and it...
Hi all, my 96 355 has just been in for an engine out service, before the service the car stated going into limp mode once it warmed up and would...
thanks for your input I’m a little confused as there seems to be a few people on this site saying to press out the bearing And replace the...
thank you
If you could please take a photo that would help greatly!