© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Just did a scan pulled these codes [ATTACH]
Odd thing happened couple weeks ago when my dct started acting up. The trans would only go into 3rd and 6th gear, no codes no dash warning...
It’s all back in and everything works again. Sent from my iPhone using FerrariChat Except the shift lights Sent from my iPhone using...
Blinkers stopped working and there are only two different NVO boards you can buy early build numbers up to around 2013 years and after for the...
Maybe pavers are the way to go as you can always regrade as many times needed Sent from my iPhone using FerrariChat
Good I was going to suggest getting a couple different concrete guys to come out and give bids and suggestions. They will be really harsh on the...
Just fyi if anyone finds this later and is trying this for themselves I took a piece of flat metal about 3 to 4 inches wide around 6 inches long...
Usually they would cut the drain later. Big driveways and foundations or poured in a day as that makes it the strongest and usually the least...
Yes and it could "heave" with moisture getting in the joint and becoming uneven as it's not one piece like it should be. You could ask them to...
Oh wow no show, now you have a cold joint in the pour and on a slope is not ideal.
Pic for reference [ATTACH] Sent from my iPhone using FerrariChat
Just watched Sticky RX vid and if you pull the carbon lower face plate you tear the foam holding the piece in place. What I can't figure out is...
I can’t figure out how to remove the lower carbon face plate to get to the tabs [ATTACH] Sent from my iPhone using FerrariChat
I'm stuck getting this blinker control board out. Have removed the air bag, unplugged all the connectors to the bad NVO board but there is no...
It's a night illumination light, comes on when your headlights are on or when the sensor turns to night lights. It will flicker for years then...
Did you reuse the brake shims? Had to do a little modification to the shims as the sensor protrudes out the back of the pad Sent from my...
Changing the brake pads out and ran into a little problem. The slot for the sensor on the Pagid pad only has one slot for the sensor and they are...
What did you use to remove the material ? Was it hard to do?
Has anyone done the filing procedure on the brake pads to make the same profile as the SF90 brake pad? This is video is over 2 years old and I am...
Lots of good exhausts for the 458 just depends on what your taste is. I went with iPE 200 cel valved exhaust, and Fabspeed headers and beyond...