© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I would like to follow up on what I found. The CD player was replaced with an Amplifier for stereo system. It was mounted on non conductive...
We all learn something new!
I purchased a new Yellow Optima and it does not fit - too hight Does anyone have a recommendation for a replacement battert? thanks
Double checked the battery goes to the insulated side (white plastic) and the chassis side goes to the upper non insolated
Thanks for the drawing Question there is an isolator on one side is that the battery side?
Not that I am aware of but it’s is acting like it’s bypassed
Does the wire going to the body go on the isolated post?
It cranked and started
No charger connected and there is an AMP but the wire was disconnected so I am really puzzled
I turned off my master switch to replace the battery but the everything in the car stayed on? I removed the switch and tested it and when in the...
Great Link - I will pull that plate as well and see if mine is the same issue - I would think filing the casting would be in order to prevent the...
No it's still sitting in a box - I did contact Ricambi where I bought the part from and below was there response Daniel Pass (Ricambi America)...
I am pretty sure it's not a vacuum leak - thinking its a sticky throttle or possibly bad MF sensor. The car runs fine and will idle normal after...
This issue happens all the time when coming to a stop. It does not seem to be an issue if you just rev the motor while stoped. This is gated...
I have a 2003 360 spider 42,000 miles. I found a link here about similar issue. His dealer / service center cleaned the grounds in the engine...
I wanted to replace the oil screen or Oil Suction Fan part # 177130 since mine had a small whole on the top. The old one fits just fine, the new...
Follow up on the belt issue First would like to thank FCAR TECH great call on loosening the Alternator - that worked get for getting the belt on....
Quick follow-up - removed the belt and adjuster pulley and the stud that is suppose to move is stuck - I will remove the mounting plate to see...
I will check on the belt number I think something else is going on I would think the adjuster should not bind with little movement. It’s like...
I just finished the belt service and was putting the accessory belts on after test running the engine. The AC and Power Steering belts went on...
