© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
For my 79 GTS I had to remove the windows as it was not enough to just undo the central bolt. You could try to remove the carpet without touching...
I have the Dino parts ignition setup and it's pretty straightforward to install and set up. It's a bit pricey but I'm happy with it.
What has happened to the European market for 308s? A couple of years ago I looked at cars on mobile.de and there were plenty of GT4s around 50-60...
My son opened his package yesterday and I have to say it’s pretty good. [ATTACH]
I bought one for my son as well (but it's partly a present for me).
Thank you both for the tips!
Hello, I want to remove the panel circled in yellow. I understand I need to remove both screws but then can I just pull the panel off and then...
Your manifolds look almost exactly like mine when I had them off last winter. I did not do anything about the corrosion and just put a new gasket...
Thanks everyone. So I will the remove the console. I’ll try Alex308qv’s suggestion about moving it to the side to see how that works for me.
I’m planning on removing the shifter and shifter box so I can take it apart, clean and lube it. what is the easiest way to get it out of the...
I did the same mod with the soft copper tubing and it seemed to have worked for me as well :)
I also had issues with Superformance caps for my -79 GTS. The distance between the rotor and the center contact on the cap was too little so would...
When you remove the bolts holding the cam caps be very careful that you don't drop them or the washers down the oil galleries because it can be a...
Nice engine stand. So what height is your garage then? I'm asking because at some point I will have to pull the engine and my garage ceiling is...
Below is what I wrote in a separate thread on a similar issue. Did the car suddenly started doing it or has it been like that during your...
Regarding the creeping idle, are you sure the progression holes in the carbs are not exposed at idle (thus releasing more fuel into the engine...
Probably the last drive of the year. Stopped at the entrance to chateau d’Ansembourg for a quick photo. [ATTACH]
Thanks for the replies. I think I will run a wire from the fuse board through the console and then into the engine bay.
Hello, I'm in the process of installing an electronic ignition and the ignition controller needs to be wired to 12 volt that is constant (i.e....
Can it be fuel delivery related? The pump might struggle once warm?
