© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I'm based out of Denver, but I've done other races on occasion.
Sorry. I build cars for a living. I have very little time for internet loitering. I promise a build thread if I'm successful in finding a...
The $500 rule is pretty flexible. The organizers will strictly enforce it for a car which is obviously able to contend for the win (Miatas, E36s,...
I agree, that is the ideal candidate, and most likely to be found in this type of condition.
I'm planning on building the first Ferrari in the 24 Hours of LeMons series, which I've been participating in for a decade or so. If you're not...
I am looking to buy an absolutely terrible Ferrari. It can be rusty, burned, or lightly wrecked. Missing engine is OK. Missing body panels are...
I'm sorry, but aluminum absolutely DOES corrode. As AandSC stated, corrosion is common in the aviation world, and it is one of the biggest...
Trade for a set of Novitec NF1's?
As far as the campaigns are concerned, you can call any dealer and they can look up the VIN to see if there are any campaigns that are still...
Marriage is a commitment, but divorce is FOREVER. Congratulations!
Hard to tell via the Interwebz, but that sounds like an accessory belt to me. Try turning the climate control off and see if that makes any...
Tack weld a washer onto the head of the screw, then use a small slide hammer to pull it out. Once the valve cover is off, heli-coil the hole....
Just drive it regularly. Mine came with a battery tender but I've never used it :)
I found my shopping experience to be very similar to yours. I shopped for about 6 months, during which I found the same cars listed over and over...
Hi all. Not sure if this is the right place to post this, but my father was the original owner of chassis # 01416. I stumbled onto this thread...
I bought a pair of these from Rizzo a couple weeks ago. They arrived more quickly than I expected, given that they were shipped from Australia....
Thanks for the responses. I guess I now have one more project to add to the list!
Good stuff.. but the finish will be wrong if it's CNCd. I don't see any way out of that without blasting it to get rid of the tool marks, and...
jg360, I saw a thread a while back about CNCing one.. was that you? To do this would be difficult.. at least, beyond what I have in terms of...
Hello all. I'm wondering if there would be any interest in this part. I have lots of experience with castings and was wondering: If I were to...