© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Sent a PM. Thanks!
I will take the starter support if available. Please check PM Thanks!
Hi Gary, PM Sent. Best Regards, Alan
Hi, I will take them, please see PM Thanks! Alan
It's been a long time since I posted anything, but I stumbled across this website 288gto.com which shows a time lapse video of a trashed 308 being...
Hi, just if anyone is interested, I pulled the exhaust off of my 1977 308 GTB some time ago and out of curiosity I removed the heat shielding to...
I have a light weight aluminum flywheel, but unfortunately, the guys that made it went out of business. By the way, they had to reuse my ring...
Sorry, missed this, I'm pretty sure your going to have to have custom pistons made. Concours Automotive had a custom set of 10:1 JE Pistons made...
Hi Guys, Some time ago I bought a 328 crank to swap into my 308 motor. I purchased the crank from T. Rutlands. Before I purchased the crank,...
Hi Lawrence, Frankly, I don't know yet, but I will be checking shortly. I already checked the deck with a machinist straight edge and it looks...
Yes, I had convinced myself that to do a top notch engine rebuild I should remove the cylinder head studs and clean out the threads and use moly...
Hi all, After a lot of effort, I was finally able to remove the broken stud on my 308 block. As I mentioned in my last post, I used a propane...
First the good news. My home made collet for the snap on stud remover works great! With my propane torch and my impact wrench, the stud with the...
Sorry for the late response. My computer had a few problems. Anyway, thanks everyone for your suggestions. Nick, thank you very much for the...
Aarrrrrrrgh! I just stripped the threads on one of the cylinder head studs on my 308 engine!!!! I had purchased a complete set of Snap On...
Uhhh, T. Rutlands quoted me the $70.00 per stud which nearly floored me. The allferrariparts.com site had them for $20.00 a stud which seems a...
Sorry for the late response (I've been working to hard to check the forum). Thanks everyone for your advice. Your suggestions are greatly...
Thanks for everyones thoughts. I guess I'll pull the head studs out and replace them. It looks like its going to be a major pain. Any...
Hi, I have a couple of questions I thought I would ask before I begin reassembling my 1977 308 engine. My engine has been in pieces for about 4...
Dave, Would you mind going a little further in your measurements? I'm interested in the distance between the centers of the inner tie rod...