© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Wanted to post results. Thank you all for guidance and brainstorming. Bypassing the sensing wire to main B+ at the alternator brought charging...
Thank you for the advice. Are there any downsides to leaving the OE sense wire alone and to run a new sensing wire to rule out the cause?
Qavion, Really Appreciate this ... Thank you! Planning to test for continuity to batt and resistance between S and Connector @ Alternator. What...
Alternator has been changed, it was not charging. Now the charge is at 16V+ Charge Warning light intermittent - but charge is consistently above...
Hi, thank you, was in contact with Algar, but he replied that they were reserved for a service customer.
Yes a very nice and helpful person by name of Constantine from Black Sea R&D, provided a set of his super bearings for a Porsche 928. Thanks for...
Hi Have tried to sourcing part #4 from the usual vendors with out luck. Can't find any new or overhauled assemblies either. Hoping forum members...
Thanks AVIMAX. Did you consider changing the torque tube bearings?
Started off intermittent 1/5 times car was started: Noise/level sounds a lot like failing power steering pump. Clutch slippage at high rpm....
Thanks to contributions of members here, have finally solved the issue. Replaced all hoses:[ATTACH] Re-crimped the reducer and re-used ends to...
Hong Kong is a small market, there are no true PS/Hydraulic specialists and certainly not many independents that are familiar enough with this...
Thanks for your reply. Intermittent warning light for the suspension but goes away after start up, and only see it may be once every 15 times...
Cribbj - Thank you so much for posting this info and your advise. As you pointed out, erroneously measured for PWM and Voltage, rather than...
Apologies for delayed response. Been so busy, not had time to post. Happy Holidays Everyone! Purchased a new Solenoid - Tested Ohm 7.9~8.1 with...
Just found this info from a BMW forum. Same 6V rated spool valve should measure 8.5ohms. They use 9V batts to test. I will do the same...
Thank you everyone for your posts. Was that bet made on a 456M or 456? Is it a possibility that the 2 ECU versions output to be PWM on one model...
Qavion - Thank you for your advice. Finally getting around to spending time on this issue. Retested inline as in diagram with multi meter...
Qavion - Thank you for your reply. Yes via test harness connected output of module to servotronics solenoid at the harness connector rack side....
Unfortunately a new factory Steering ECU did not remedy the problem. Scratching my head, thanks everyone! There is voltage @ the servotronic when...
Continuity from Harness @ Rack to Servotronic ECU Harness side - 2 pin. Voltage 0 across terminals - Harness @ Rack - with car at speeds....