© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
.05 is pretty much fully closed. Are you sure there isnt an air leak somewhere? Its been quite awhile since i worked on one but with the idle air...
The salt though... its making me cringe.
Agree. Due to leakage, I just had to remove a whole assortment of these "upgraded" hoses installed by a prior owner that were branded from a...
This exact thing happened to Clark Griswold and well it made for a hilarious scene with so many reusable quotes.
I believe fuel trim has a multiple mappings depending on RPM. I.e. it's not a single trim it's dependent on rpm. And at open throttle that all...
The previous owner of my spider had built a nicely crafted small enclosure that replaced the glove box. When the convertible boot cover is on you...
Even their truck extensions look suspect to me. I'd favor putting some 2x like a 2x12 or whatever is needed under the quickjack.
There's one at harbor freight that many have used. I think it doesn't go down far enough though. May depend how high you stack stuff under your...
And to show it's clear as mud my 97 spider is Teves. It probably happened in 97 when they ran out of Teves they converted.
Because there be very little extra clearance to use a dolly that let's you lift and help position the cradle. It will have to be very low profile...
Have you put it back in yet? I always thought it would be possible to get it out but putting back in with the quick jack would be the issue.
I couldn't make it to Geneva this year but along that theme I also noticed the BRIC wasn't as well attended either as the paddock was thin....
Confirmed my thoughts.
Is it worth it for the 308 filter size? I have the 355 size Hill tool which as noted above is very nice. I never felt like I needed one but...
I worry I can't put enough miles on. Nothing worse than letting modern fuel sitting around.
I think delphi makes one that replaces the sensor in the existing tube housing. You may need a security bit to remove the old one. I can't...
As the old saying goes.. if you want it done right. Of course that is if you have the know how, ability, and most importantly time.
toss a small battery powered bluetooth speaker on the floor. lol I'm kidding. ... sorta.
Alloy Wheel Repair in Barrington. I've never used them, but know of someone that has had Ferrari wheels repaired there with great satisfaction...
Basically I think so. The pressure regulators are both operating properly and equal all should be the same. Going back to the posters issue....
