© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
A lot if good replies in here. Thanks all :-)
Is anyone able to put a figure on the repair? I'm in the UK so particularly interested in £ pricing It sounds as though the only sensible...
Hi all, I've been considering a 2010 - 2013 cali long and hard but I keep seeing conflicting information. Some say no problems whatsoever,...
Hi everyone, considering a Cali. Question is do I stretch for a 30 for increased reliability? I read that these are less likely to develop the...
Thats reassuring. Thanks folks
Hi all, I'm in the process of buying a 360. I noticed in its service history the throwout bearing / release bearing failed 6 months ago. The...
thanks Randy. So no computer for bleeding just switching gears? This is what I like to hear!
Thought as much :-( Any affordable diy tools for this to save the car having to be flat bedded 50 miles to the shop?
While doing other work I noticed my clutch block was seeping. Tightened the nipple and it leaked badly. can I just replace the block and top up...
Thanks guys, anything else I need to swap? Small things like gaskets etc required?
Thanks! The only thing I've heard that is different is that the studs where the manual gearbox mechanism connect to are too short for the F1...
Hi everyone, I'm considering all options after my diff failed in my 360. I've been offered a replacement box from a manual 360, mine is an F1....
Thanks Mike, it was AV Engineering I was speaking with but I'll give BH a call too.
I seen that Mike, having called them they have no stock. The factory also have no stock although are apparently 'in production'. I spoke with...
Not yet Chad. Will post pics when I do
Got the shaft off today. Noise is still painfully obvious :( Options seem to be : A: Replace Trans (£5,500) B: Rebuild Trans (£800 labour for...
Thanks everyone. I plan tomorrow to remove the shaft and briefly run it to see if the noise persists or if it has disappeared with the shaft....
Haha I doubt that too! However... If I’m not able to trace the noise by manually turning parts how am I meant to track down where the problem is?...
Another odd development... Spin the wheel this morning and ...nothing. Wheel spins with about the right amount of resistance but no clank clank...
Just got the car home. Couldn't resist a quick jack and spin of the wheel. This is in neutral : https://youtu.be/14cAuDyNxwk Any thoughts on...