© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
@Zenobie called it - shop fixed it. Plug wires loose inside distributor cap and main wire from coil to distributor on 5-8 bank. The frustrating...
Well I have an appointment to take the car to a professional. In the meantime, I swapped the relay and I was noticing the two relays I have both...
Just going thru everything I've done since September to the car. I had replaced the fuel pump with a Bosch 121727. That seemed to fixed the...
Replaced plugs - no change. Replaced ignition coil modules - no change. After 20-30 mins of driving cars run great, but up until then sputtering...
New board back from GTCP last night and installed this morning. Car is definitely running better. Idle is smooth and correct now. I can rev the...
Mine did not look so good either. Plus the burn through where the fuel pump connector is. I like the idea of holding onto all the metal relays -...
Board has been shipped off to GT Car Parts. If the connection was unstable, this maybe could be the cause of my poor running condition? I guess...
I'm thinking about the coil modules over the coils - speaking to a friend this morning at Cars and Coffee, he said he had a similar problem and...
Checked the vacuum actuated valve - it works. Tightened air hose connections. Checked fuse box and there is a problem there, although I need to...
It does sound the same. I will research if there is a way to test the coils also.
Thanks - I installed the injectors with new O-Rings. Will check the hoses as you suggest.
Thanks for the advice. I looked at the hoses and squeezed them and they seem reasonably pliable. However I will warm up the engine and tighten...
Reference my 87 328GTS (US Spec). I've searched the forums and on here and several CIS sites and have not been able to find this issue. Had a...
So I used the Sharpie Paint Pen, not perfect. I may try to redo with a Paint Flow Pencil... [ATTACH] [ATTACH]
And the results...not hateful, but not perfect - like I said, I may have to redo it... [ATTACH] [ATTACH]
Very helpful - thank you. I bought a sharpie fine point oil pen yesterday and I'm attempting with that now. I don't think it's going to be as...
Got this fading on the white paint of my rear badge - not sure I have the skill to fix it - any advice much appreciated... [ATTACH]
My 87 328 GTS looks great except this badge on the rear. The white paint on the GTS is virtually gone. Would love to replace it (or fix it)......
I ended up buying new ones - at the time I couldn't find a shop that would machine them - have since found one, but had already installed the new...
Hi - I pulled a set of front rotors off my 91 TR with a slight vibration. Car had 13k miles on it. I was thinking to have them machined and...