© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Just saw you comment; I apologize for the delayed answer. I believe that plastic hose from the back of each cover is oil/air Breather and attaches...
I wish an admin could change title to “DIY Cylinder Head & Valve Cover Gasket Change 599.” “Head gasket is incorrect of course. Sent from my...
Thanks! Ferraris don’t have to be “unaffordable.” My goal is just to share my experience doing it myself. It’s a great feeling driving a car after...
[ATTACH] I replaced a couple of the hose clamps/brackets. Two different part numbers / two different clamps to order and be ready to replace....
[ATTACH] Now I got the plenum on. Again, a second person is really crucial here. I didn’t have that and it was stupid to try. Luckily I planned...
So the job is done and the car is running great. [ATTACH][ATTACH][ATTACH] [ATTACH] When installing the runners, a second person will help so...
My foam had oil on it too, both sides. No way this is as expensive as listed. Sent from my iPhone using FerrariChat.com mobile app
Anyone familiar with #29 in the diagram? Supposedly part number 237901. It’s just a foam piece but is listed as $310! Is the cleanable? Should it...
[ATTACH] Left cylinder head cover installed. Up next, borescope each cylinder for an inspection plus checking for debris. I’ll blow out each one...
[ATTACH][ATTACH] [ATTACH] Right side assembled. Don’t forget to push in those little yellow plastic clips in each ignition coil connector. I use...
So, another thing I’d do different is buy new o-ring seals for the camshaft sensors (2 per side, sit on the aft part of intake manifold). Mine...
To get the solenoid C-clamps back on, I just tapped them in with a light hammer and file with some electrical tape on the top to not scratch...
[ATTACH][ATTACH][ATTACH] Some random assembly pics. You can see the excessive heat protective wrap I use on that back corner as we’ve found it’s...
[ATTACH][ATTACH] There is the gasket maker I used. There is the swivel socket I used. It’s a bit shorter than the one in my set. Also, if I...
Oops, those posts are for a different thread of mine. Sent from my iPhone using FerrariChat.com mobile app
I’m torquing all the screws now. WSM says 11nm = 97 in/lbs and I’m doing 100 in/lbs all around. I’m doing 110 in/lbs on the difficult to get one...
This is needed for the right lower back corner screw for the cylinder head cover, by the metal oil hard line. This specific swivel socket was...
Anyone know who is rebuilding MAFs for 348s currently? Cost and timeline? From prior research, if I recall correctly, rebuilding is the only...
No. That is an oil breather line with a one way valve on the side with the heat blanket. It connects to a port on the oil fill neck. - the rubber...
[ATTACH][ATTACH][ATTACH] Cylinder head covers are back on. We spent a lot of time to make sure the backs were aligned properly. We even used a...