© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
thank you….not sure what the shipping across the pond would cost but good to know, thank you!!
Really detailed GTA transmission question, has anyone else had their upper valve body apart and know if it’s correct there being no spring in the...
I have discovered, after a first drive of my recently-on-the-road 456m GTA has revealed it appears to have part of it's transmission breather...
This plug was the one …..I haven’t checked the colour codes, but bet this travels to the transmission control unit and/or digitek unit in the...
So, as I think someone predicted, this was not the end of the transmission error….but by chance when it recurred I removed the ventilation...
Yes, left hand side boot (trunk) near the light unit, under the trim mounted on a bracket from the ceiling of the boot. Having seen the non-M...
so….unplugging the transmission control unit and digitek box didn’t seem to do anything, so I decided as a next step to check the non-moving gear...
My assumption was that it would be a bad idea, just checking! ;)
With vehicle battery connected ?…and if so, ignition off?
Thank you @Qavion - the power supply info helps. Given no other issues as you say, I don’t think this is very likely to be power supply related,...
@Qavion do you have a wiring diagram to understand which fuse/supply allows the gear-lever solenoid to move - and allows the key to release from...
All back together, working perfectly from both key locks, the alarm fob and all internal/external handles - very satisfying. Now...if anyone...
So, all fine with the wiring from the door multiplug through to the central locking actuator plug (though the door-side pins did seem a mirror...
Thank you for the wiring diagrams and pin layouts etc....much appreciated....now to have "fun" with a multimeter!....
So....I'm making progress. I think I had a couple of issues related to position of the levers into the latches etc., but having logically got all...
Given so far I am finding no electrical issue, and even with all rods disconnected it does the same thing, this sounds very possible. Is it a “new...
Thankyou! Yes, I have done this, although in my case it hasn’t resolved the issue, but it’s a good shout and I’m sure would have caused issues.
I’m starting to think I just re-assemble - does the mechanism need some preload from the internal handles and rods to work properly perhaps?
I’ve tested now and As far as I can tell the micro switches are all fine, the four pin plug to part 18 tests the same on both sides. It behaves...
I’m nearing the end of recommissioning my 2001 456M GTA (Rosso Fiorano, RHD), and have run into a central locking issue - it was fine before...
