© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
o_O:):cool:
no i did not clean that yet
then i don't know why the rpm's where better , pressure whas higher and pressure light didn't light up. maybe because of put down the aircon...
do I have to suck out the excess water now? instead of unloading the plug under a radiator because then it might drain completely.
can i also bleed the cooler circuit by running the engine and leaving the expansion fat cap off for a while? or let it warm up a bit not to...
do I have to remove the plastic cap around the water expansion tank and between the cylinder banks to access the breather / bleeder ? [ATTACH]
Yes it went on some times and then the idle went a bit down but much higher then before the cleaning of the pressure switch contacts. also...
I had problems with low oil pressure and the light sometimes coming on when idling. the engine had warmed up and I had to top up two liters of...
Think it is a 5.2 I did a 10min idle reset and it stayed around thé 1000rpm. Is it maybe because of cleaning thé contacts from the pressure...
i didn't clean the IAC's with it , only the contacts from the oil pressure switch
I have a contact cleaner in spray. am sure. bought it last week. but I didn't find him right away. will do it again with the right product.
scary i go for doing the battery reset/idle relearn procedure and maybe cleaning the Idle air controller first. i first need to know how...
because the revs drop at idle so sometimes the light of the lower oil pressure comes on. if you give it some gas it goes out. yesterday I cleaned...
thanks Quevon for your help, the belts, brake and engine fluids, oil filter and valve cover seals have been replaced. And I presume the air...
I know, i am also new on the f-chat site and not so into computers, but i search on the f chat after my problem and hope someone has the solution....
the switch i mean. Not the gauge. can you change the switch while the oil is in?
can you change the oil pressure switch/gage without draining the oil ? do you need to change it when cold ?
I replaced the fans. Now the fuses won't blow anymore I hope. Tested and they both run. That's okay, but since my last major maintenance I have...
I shot it down and whas really affraid thanks die al thé help and reply . It wil be repaired and Geys all rhe Care needed [ATTACH]
I also made videos but they are too big to send apparently [ATTACH]