© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
While cleaning up the wiring harnesses under my dash, I came across this wiring harness going to nowhere. Can anyone confirm that it isn't a...
Thanks for sharing; I couldn't figure out how to stop the blinkers!
Those Tubi headers aren't as sexy looking as other aftermarket brands, but if they are as effective keeping heat out of the engine bay as stock,...
Interesting idea. Aren't you concerned that the spring will chafe the liner or top? I recently replaced all my straps (and there are a lot) using...
When I installed my bumper, I left all four of the front mounting bolts loose as I aligned and tightened the sides. Then, I tightened the front...
I want to turn over the engine without fuel being injected. Does anyone know if I should pull the fuel pump relay, or the Motronic fuse?
I noticed the engine running rough after a trip to the gas station. The Launch X431 indicates P0306, cylinder 6 misfire. I swapped the #6 and #5...
Whatever works, right? I didn't want to glue the key onto the water pump shaft, and I didn't think grease would hold it tight enough. A little...
That did it. I dried a little blue thread locker on the back of the key and took a mini file to the key way. Then, ensuring maximum light, I...
Reinstalling my new/used pulley, I now find it likely that this is what happened. While the new key fits loosely into the new water pump shaft...
What's the best tool for opening up the ring nut (besides a screw driver and hammer)?
Thanks for your advice, Rifledriver. I was reluctant to use my impact for fear of damaging the bearing, but I'll use it next time. I also didn't...
This may have happened. Or more likely, I failed to ensure that the pulley was torqued properly and the key slipped off during operation. In any...
It engaged the key. The problem, I think, is that I couldn't tighten the pulley nut fully without the shaft spinning after I installed the pump....
Perhaps. But the current pump only has 330 miles on it.
I threw my water pump belt last week, 330 miles after it was tensioned as part of a heat exchanger replacement. I assumed that I under tightened...
Yes, I should have taken pictures while it was off. As it stands now, it's close enough and looks fine at five feet. I'll revisit this bumper...
I was able to lift and push it into place while another tightened it down.
I got the bumper up high enough, but the top edge in the wheel well wants to poke out a little. I'll tackle it another day when I get a better...
I had no idea that there was a rubber gasket on top of the bumper until you mentioned it. I looked it up and it's not cheap. I guess it keeps...