© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
The larger hose from the engine block to the oil tank is m30, but it doesn't have a 90-degree fitting.
These are M26 nuts, so unfortunately, the M30 won't work. They are m26 1.5 pitch.
Answered my own question. The 90 degree fitting will work, it is the same pitch and diameter.
Hi all: The nut on the 90 degree fitting has broken on my 355 hose which runs from the oil tank to the lower cooler (part no 145041). I've come...
Hi all: I need to get my front fenders rolled on my 360 - anyone have any recommendations for someone that can do this in the Bay Area...
I am about to find out. I have the Fabspeed on there and my smog is due. My OEs are plugged up and toast. I was hoping the Leno's law would...
Hi all: I need to replace the washer fluid lines and windshield cowl drain hose on the driver's side. I am not seeing any way to access these...
Check the batteries with a reliable tester once charge and then get a new tender with desulfator. I use the batteryminder with desulfator on all...
I have spacers/bolts I am planning to ditch. I need to measure the width though. PM me
Hi - its slightly different. I have the single yellow wire shielded with the zipper tubing, then the black wire is within a second shielded...
Thanks everyone. I did one drive cycle and all of the I/M status shows ready except catalyst. There are still no pending codes or stored codes....
Hey all I’m looking for a solution to the P0420 and P0430 codes that are “permanent” codes. There is no CEL but all sensors clear for smog but...
Thank you so much!!
Hi all: I am putting together my 355 and correcting a lot of shoddy work and incorrect installation of parts along the way. I am looking for a...
As a follow up to this thread, if you are replacing these P-clamps, many of the rubber liners have hardened and crumble in upon removal. While...
It's certainly your right to use or not use anyone you like for any reason you like. GTE was never recommended as a rebuilder, only as a referral...
Just wanted to be clear here, I did contact GTE after you posted which I thought was a good suggestion, especially given my good experience with...
Yes, I understand that the logo-embossed bolts can still be obtained from various parts sellers.
Hi I checked with GTE who rebuilt my clutch on my 355 (did a phenomenal job). They do not rebuild the shocks. So I think the only real option is...
I know these. I will do this next with my TR, that looks amazing! Really freshens up the engine bay.
