© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I like the wool too. Thanks for the breakdown!
Looking forward to seeing them. Which mat did you choose? Original Coco?
Thanks Guido! I remove the beauty cover over the brake reservoir and the wire cover below that which helped me pull the wires up. There was a bit...
Hi Stasha, 1)There are 8 connectors so it is a lot of slot cutting. I was very cautious at first but after a bit it becomes easy and you would...
Fuse panel installed with a few tire wraps to clean it up. [ATTACH] Cover on [ATTACH] I connected the battery back up and everything works!!!!
The first three plugs installed easily, then I had one fell like it was hanging up on something. Following instructions, I kept all the connectors...
A fireworks of wires! The picture shows the fuse panel in place, but I sat the panel up on the trunk edge to install the wires. [ATTACH] I...
Plastic plug ready for the Dremel. This one only has four that need to be cut out so I marked them. [ATTACH] The cut out process, repeat and...
On with the wires. Before removing wires from the connector, I took Guido's advice and wired the wires together on order of placement (and took...
I did it the hard way. The project is finished, I just got tired last night and paused the posting.
The new board is screwed to the panel, sorry, I neglected to snap a picture of it. The first time I screwed the new board to the panel cover, but...
Panel before disassembly [ATTACH] I took pictures and laid out the removed fuses and relays. Then removed the back cover (5 screws) [ATTACH] I...
The panel is attached with screws from behind [ATTACH] Before removing any wires, I labeled the connectors and panel locations [ATTACH]...
The fuse panel in the car [ATTACH] Disconnect battery, located ahead of right front wheel [ATTACH]
[ATTACH] It will replace this one [ATTACH] But first, how to get it out..
Over the winter, I replaced my fuse panel circuit board with one from Guido. I will share my steps. Hopefully it adds to community knowledge. To...
Grigio, Nice, maybe I can see that some day.
Looks nice! Whichever number of the 43 yours is, it's the next after mine if it went by VIN. Mine ends in 834. Good luck, I hope you do well!
Sorry I misread who posted and my prayers go out to Roc's family. Your VIN plate does not have month & year stamped?
Hi Roc, curious on your build month, my 81834 is July 89. Other coupes I have recently seen online are June 89 including later VINs than mine.
