© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
ok, so do you think the 456M doesn't utilize Can-Bus for their wiring system?
We used a breakout box plugged into the OBD2 port to check power, ground and can lines Pins 6 and 14 are marked as can h and can l. is this not a...
Makes sense, since i could not get a resistance value across OBD2 pin connectors 6 and 14. I assume should be 60ohms like all other can line...
ok, this helps alot. I'm wondering if the 120ohm resistor has shorted out or is faulty causing the issues with no communication? where would the...
Hi Qavion, Ok, checked power to the right ECU and has power to pin 26 and ignition power on pin 56. Was reading up on CAN Line issues and did...
ok thank you. good place to start. I'll have this checked and let you know what if find out.
ok, sorry for the long delay in responding. As the fuseboard seemed to be having problems, went ahead and ordered a new fuseboard from Guido...
Ok, will will check the board first and let you know. thanks for all the advise to date.
Tested all fuses and they are fine. The fusebox seems to have had some burnt areas that were repaired recently. Wondering if a damaged fusebox...
Sorry, car is made for north America. yes there is an OBD@ port, but apparently the scanner cannot communicate with the ECU's. Can the ECU's or...
Hi Colby, I know this is an old thread, but I'm having the exact same issue with my 456M. What was the final prognosis of the no start issue? What...