© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Sergio, You should be able to file a complaint on Ebay because it does not fit the car described and does not match the description or photos....
[ATTACH]
Schulz308, A leaky injector(s) really does seem to fit my initial run-on problem. What confuses me is that the problem went away by the service...
As a follow up. With the help of fellow forum member CaptOHarry, we cleaned the air meter plate under the air filter and cleaned the throttle body...
All - Thanks for all of the replies! I am not ignoring them, I am doing lots of research on checking the valves and cam timing before I jump on...
I pulled one spark plug - the easy one! And it looks like I am due for new plugs. Do I look for Champion A-6G per the owners manual or replace...
Rifledriver, Thanks for the response. I did not drive the car when I first got it other than directly off the truck into my garage as the belts...
Hello All, My new to me 1987 328 diesels a second or two after shutdown. It did not do this when I first got it a few months ago. I have changed...
That is what I will do too. Thanks!
Like the title says, what is the proper routing of the O2 sensor wiring? Mine seems long and hangs down on the exhaust. It has not burned or...
Perfect - thanks!!
Is this what you are looking for?
I managed to get the hub off. Turns out it was old sealer holding it on. New question: how deep should the new seal go? Is there a lip inside...
As a followup with some questions. I managed to get the 12 bolts out that hold the axle shaft/cv joint assembly fairly easily using PB blaster...
Just did this today and l I did not have a 3' extension but I did have 3' of extensions and you are correct, that is absolutely the secret. Piece...
Thanks for the info. I have a variety of hub and gear pullers, so I am probably good there. I will find out when I get in there! The seal install...
Item 2 is called out as a bearing. I can not find a seal. Any suggestions? I think I may have found it - part #125078
Great writeup by birdman308. I just picked up 2 cans of PB blaster and will start that process. I will order a new boot, some grease, new clamps...
I found this image on the Ricambi website. I hope it is OK to post it! Does the end labeled 4 on the axle shaft connect to the inner/differential...
While changing my engine and gear oil on my new to me 1987 328 GTS, I discovered a leak at the inner passenger side axle shaft boot. The boot...
