© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
The actuator has 4 nuts that tighten the actuator bracket on the engine. Loosened those 4 nuts and pushed the whole unit towards the transmission(...
Hello all. Just an update for this thread incase it is of any use to anyone in the future. Finally got all my shifting issues fixed in the 355....
Hey Qavion. I have checked the resistances of all the solenoids and if I manually engage each gear (with the help of a power probe and external...
This is some great information and thank you. But unfortunately I have good lights and my fuses are all good. I have checked the fuses on various...
Hello all. I have an update for the 355. First of all I would like to thank everyone in this thread for all the amazing help and insight they have...
Hey. Sorry I got busy with a few other things as well. Got an oscilloscope as eric had advised me to do so and take some measurements from the...
I bled the system manually first, hooked up the pump to an external supply and opened the bleed screw on the upper side of the pump body. I would...
After I leave it overnight and I come back to the car, ignition on and engine off the F1 light does not flash at all but the pump runs for about...
I tried it both ways. I just pushed it once with the brake fully held down and engine on and after engine off as well. Then I held it down as well...
Yes it does. It also turns on and off when I actuate the brake pedal. But maybe there is another input it's reading to display the brake switch...
Engine on parameters [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Engine off parameters [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
I fit the dashboard back in place including everything with it except for the instrument cluster. Thought I would try out what Rob had mentioned...
Hi Rob. Yes, I completely agree the people here are so amazing and knowledgeable. I would not have gotten this far without them. I am truly...
On the other side of the board the large pins(that connect to the harness on the outside) are directly connected to the opposite side of the...
No I dont think so. The F1 system was completed in march 97 and they started selling the car.
Oh sorry about that. Glad I was able to clear that up.
This is with the TCU and dashboard connector disconnected. The display unit is connected. Without the display unit no wires have continuity. Did...
Sorry the access permission was on restricted. I have changed it. Its just a few videos of tracing the pin 25 in the TCU. So when I set my...
I got a new problem now. 2 days back I was using the SD1 to shift gears. Did a cycle of all the gears start from 1st. Went upto 5th gear with the...