© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
It dies if I touch at idle that was meant to say
It does if I tough it at idle, had a go adjusting it with a colour tune and it’s set up right, but it should still rev even if it’s a bit out
Mine won’t even rev enough to get out the garage, I’ll double check it again
Done both of those already, so far it’s had fuel filters, pump, pressure regulator and newly rebuilt distributor - i must be missing something...
Essentially, when I give it throttle it moves the plate a little bit and pops and bangs, when I give it a lot of throttle it eventually picks up...
Pushes down very easy, although when the fuel pressure builds it’s a bit harder, could it be that the fuel pump is too hard?
Hi guys, Resurrecting this thread as I’m still having issues, moving house put the car on the back burner but need to get it sorted. so I’ve...
Hi guys, mum still struggling with this on and off as I haven’t had much time to play, the return line has flow, I’m starting to wonder if the...
Yes moving freely, I haven’t checked the pressure, I’ve fitted a new fuel pump too. it’s electronic ignition I think, it’s a 1984 mondial QV with...
So by adjusting the mixture ever so slightly it’s idling well and revving well but as soon as it’s under load it’s popping and banging a bit,...
Would that be clockwise or anti-clockwise, it’s a bit Smokey when you rev it which makes me think either too rich or too lean is there a good way...
I did but I measured them with a caliper to get them back to where they were, so shouldn’t be too far off. which one is the Co screw? Is that the...
Hi guys, rebuilt the distributor today, it seems like it was covering up more issues, it now idles on all cylinders and does rev but does an...
Hi guys, I’m in the UK and have an issue with my fuel distributor, it’s just constantly flowing fuel on cylinder 5 and not holding pressure....
I’ll post the readings this evening when I’m back with the car, it’s been intermittent for a while but only recently has caused the complete bank...
Well, I feel like my lazyness and assumptions have failed me big time. swapped the new sensor I thought I had fitted to the bank 1-4 to the...
Right, so just swapped the plugs on the ecu, issues still exist the same (good news for the ecu I guess) so would you think the next thing to do...
It’s bank 1-4 which is failing, looking at that diagram I’ve replaced the rpm sensor thinking it was for the 1-4 bank. interestingly putting the...