© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I find the styling lines very close to the 308 more than any other late model Ferrari. But I still think for that amount of money not enough...
The lighter the better. How do I go about to get one made in FG orCF?
What size and type of lamps were used for that GTO spoiler. Was thinking of doing the same setup on mine. Nice!!
The mirrors barely cover the existing mounting holes, so I just placed some tape over the door and bolted the mirror where I wanted, then mixed up...
Thanks!! Yes it is a blast, things happen real fast when you get on it. Feels as though the gearing is too short now. If I could only squeeze in a...
My heads have been milled to reduce combustion chamber volume to 38cc.Then factoring in a 0.060 gasket and domed piston my compression was...
I am using a Turbonetics T-66 compressor a with .69a/r turbine housing and 3in downpipe. A Spearco air/water intercooler with its own radiator up...
Just finished up my own exhaust system on my Cavalino. My first system was an ANSA which I purchased many years ago, it looked ok but resonated...
Good to see others taking advantage of the potential of the original Ferrari V8. Those motors come to life with boost. I decided to turbo my 308...
This is my set-up with 18x10.5 265/35/18 rears and 9.5x18 235/40/18 fronts. Three piece Speedlines. [ATTACH]
I try to keep it topped up to 93 octane. Does not knock.Still need to bring it up to 20lbs or so. We'll see what happens, the trick is to keep...
I am using custom forged JE pistons .020 over in O ringed sleeves and copper headgaskets.Heads are milled, valve guides were made for me from...
Just a few samples. My intake valve is 1.7mm oversized with custom beryllium copper seats. Exhaust is 1mm OS. [ATTACH] [ATTACH] [ATTACH] [ATTACH]
To anyone contemplating whether or not to mod their 308, after I installed a turbo in mine it kind of became an ongoing project. It went through 3...
I have my Motec M8 installed in the rear rt side behind the engine and it works flawlessly.Wires are much shorter as well.
Are there any 2 piece rear discs available. I installed calipers from a 94' 348 with 13'' wilwood rotors up front but was a lot of fabrication...
Is there a replacement 45 degree 30mm hose that I can use to replace those 2 hoses that connect the cylinderheads underneath the intake plenum...
Check Ferrari 308 valve guides on Ebay.
There is still a whole lot of mods not even covered by the EFI,turbo,intercooler like stronger pistons, clutch, head gasket, valves, etc. If you...
That seems doable. Would you have the specs so I could have them welded and re-ground? I am running a liquid/ air intercooler and my compressor is...
