© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Try Superformance over here in the UK. Also with the pound sterling being so weak, you should get a good deal on the exchange rate.
Hi. Thanks for the link. I'll look into it. Regards Pete
I have already fitted an Xdi ignition and have made all looms up. I do not have the finances to go down the fuel injection route and a new ECU....
Hi all. I'm now changing to carbs and have found a company that can fab me a pair of inlet manifolds to whatever carb I choose. I'm looking at...
I have a used spare one I bought a few years back for "just in case". It has a small nick out if one of the fins underneath. Haven't a clue to...
That is because the thread was originally started in 2015. Dale G reopened the thread yesterday by asking a question re Scott McG
Hi. I haven't personally, but have seen several on YouTube. Nicks Forza has a kit for $10k with some extras. Also, 928 motorsports has a kit for...
Same here. Superb service and probably more knowledgeable than most.
I've been building one for 12+ years. Sadly stalled mostly, due to long term health problems. I can hopefully give you whatever advice you need....
Hi Derek. Yes, mine are a bit pitted and would prefer them in aluminium. 50 each sounds very fair, so put me down for two (in red if poss). You...
Hi Derek. If you do decide to make any more, maybe put them in the Mondial section too. Will you be making any of the bottom pullies in aluminium...
I cannot find any reference as to the Mondial Qv having a built in oil thermostat. I am looking into relocating the oil cooler and will have...
Does anyone have a pic or a part number. I might have 2 in tan/biege. Regards Pete
If its just in the resin, then its quite an easy repair. Google carbon repairing and you will find loads of info. You could do it yourself as long...
Personally I think they look good. A nice period looking wheel. Too many purists shun simple changes, but aesthetically I think they suit it.
I know this thread is a few years old now, but just wanted to see if there are any updates to running this setup. The engine is a heavy aluminium...
It should be interesting how they sort the handbrake. I had originally planned 6 pots on the front and 4 pots on the rear, forgetting to take into...
355 18" Rear Rims Wanted. Condition not an issue as they will be repainted, but don't want any with bad curb rash or chunks out of the rims....
I looked up the numbers but could only find a basic picture of the car, with numbers pointing to specific areas. What is actually wrong with...
Thanks for the input Steve. I can't use the Hi Spec bells on Superformance as they are only 10 holes. They are suitable up to I think 290mm. I...
