© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
My favorite kind of project :) I can't believe it's been almost 15 years since I did mine.
[ATTACH] David Diesen BTW... Anybody wants to know what 9k through the Phoenix tunnel sounds like? I think I peed myself a little bit :)
[ATTACH]
Had an awesome ride. Started with the Phoenix tunnel which I went through, turned around and went through again So now you know what kind of...
Live in Arizona and spend time in Montana in the summer (Snowbird) registered the car in Montana because I could never get the car through...
Going out today for my last drive in my 308. I have surgery tomorrow after which I will not have the ability to drive this car any further. Not...
Incredible build. Definitely going to go with your headliner treatment since it's going to the upholstery shop after loaning the car out for a...
Here is a pic of Scott's installation. They just need to finish plumbing the intercooler and finish setting up the injection. It's pretty close....
First time I've seen them in 17in. with custom widths and offsets, so they will fit over my brakes and I can sustain my tire fetish :)
The billet 81 gold coffin spoke wheels in 17's OMG I got to have a set :)
Even though I was a fan of the show, I wasn't influenced. I was a musclecar fan at the time. But now after having driven my 308 for 16 years, I'm...
Picking up car from Elwood, Just fixed some of the road rash. Got some SUPER 3M helicopter blade tape for the spoiler. Gotta go drive thru some...
Windage tray installed ... Oh wait I did that 10 years ago. Was a huge difference on the track. I've never had to over fill even when we run a...
Thanks, it's been OK for the last couple of weeks but we shall see how long it takes. Believe me in this 115 degree AZ heat, i'll be pullin new...
I swapped out my compressor a couple weeks ago using a fit from GT Car parts in Arizona. Basically all we had to do was clean out my old lines,...
I've owned my car for about 15 years now, and was in the "any guy that can turn a wrench can work on a Ferrari" camp for a very brief time. Wait...
I would probably talk to Bill or Dave at GT Car Parts in Phoenix Arizona. They offer the kit I have, but also have the largest salvage of Ferrai's...
Installed both crane cams fireball ignition units into the rear distributer clocked at 90 degrees from each other. The front distributer has no...
The kit uses all the stock setup, tensioner, shims, belt, just relocates the pump higher. Also used r134. No engineering required :)
Just had my motor rebuilt at Alex Traverso's shop here in Arizona, and Bill at GT Car Parts showed me his new Sandon compressor conversion for the...