© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Don't have any pictures, but my targa top had the plastic/rubber sleeves on the pins, at least on one side. They tend to stick in the holes behind...
Leather repair services can do a decent job of making the seats look good again. Even tears and cracks can be fixed. They will look great for a...
I did this many years ago. Most of the pieces are fairly obvious as to how they are removed, but there is a guide somewhere. For what it's worth,...
Based on your description, best guess is slave cylinder "triple seals" or failing master cylinder. When the hydraulic triple seals, which hold...
Surprised no one has mentioned the door wiring yet? Very common problem. The Amphenol door connector that houses the wiring harness from car to...
Not my 348, but had a nightmare job on my Ford doing this. Broke several pullers, and it laughed at my torch. I ended up building a tool to push...
Lots of good stuff done already. One I didn't see, however, is replacing the cam phase sensor, only saw you mention the crank ones. The plugs on...
Try my348.com
My other hobby is restoring arcade and pinball machines, where I work with a lot of clear plastics that are heat damaged, stained, and just plain...
Great find! Thanks.
348 has an overflow line there for clutch reservoir. Not sure if the 355 does.
Seems like something that could be 3d printed without too much difficulty.
... Mother of God. That is a MAGNIFICENT diagram! Whoever cleaned that up, you are a true VIP.
It may not be the module, but as an added data point, that is exactly how mine was. Started out A/C was fine. Then some days it would not turn on,...
Fan power module is often the root cause of this. I spent a long time chasing issues for blower turning on, fuses, panel resets. All caused by...
Hard to tell from the picture, but almost looks like a failed solder joint, and some damaged traces that were repaired. Or, the diode got very hot...
The Service Manual has a good write up on general theory of operation, sensor diagnostics, etc. No flow chart, but there is solid explanation of...
With a heat sink like that, and all that vibration, it would be worth checking for cracked solder joints or shorts as well. I've been chasing...
That is an amazing deal. Very tempting, and it would seem like a killer investment for a shop: buy this and either reverse engineer a detuned kit,...