© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
So I was able to do a test drive today with mixed results. The frequency valve was working good so no issues there.....and the 15A fuel pump fuse...
[ATTACH] [ATTACH] [ATTACH]
So I put the new relay in and the car started up no problem but did run a little rough and seemed to be a bit more exhaust. It sounded like it...
Thanks for all the help and and yes I do have the ECU present, it is located on the other side of the plate. One side has the ECU mounted, and...
Steve, I checked and the brown wire that was not connected and was wrapped with electrical tape is hot all the time with +12V, (actual read about...
I went through the archives and found a lot of earlier posts on changing this relay. I will get the Porsche / Stribel relay 92861512402 tomorrow...
I looked at the Protection fuse and noticed it looked a little rough. There are only 3 of the terminals populated, and looks like one of the...
A quick update - I got the fuse buddy and tested it, showing current around 9.5 to 10.4 amps. Tested it with the car running for 30 min, in both...
I ordered the fuse tester (very cool!!!) and will check the fuse holder connections also. Thanks!!
Today we finally had a break in the weather and was able to do another test drive. I disconnected the AAV and WUR, then drove the car for about...
OK sounds good, I wasnt sure if I could safely drive the car with those unplugged but will try that and see if the problem continues then plug...
Is there any way I can test my WUR to confirm if it is causing the problem? If not the WUR could it be the AAV failing? Ideally would like to be...
Looks like I finally found my problem. After replacing and checking everything else it seems my warm up regulator is the culprit. Shortly after...
Hi, I wanted to do a follow-up on this thread. I inspected the wiring and could not find any obvious wiring problems. I next looked to the other...
Today I did a test drive to see if t'he improvements have worked....unfortunately they didnt work. I got about 2 miles from the house when the...
I swapped both relays and that didnt help. I did confirm the car is a US version 1985 QV 3.0. I also pulled the 20A fuse for the air...
Hello, a quick update on my quest to fix the blowing fuse. I tried what Steve suggested but no luck in fixing it. I did the fusebox rebuild with...
So a quick update - I replaced the fuel pump with a new unit. Unfortunately that did not clear the problem. I have replaced the fuel pump,...
One additional note - when I disconnected the primary power from the fuel pump to do the voltage measurements I noticed that it was only 2-3...
Update - I disconnected the main fuel line input to the fuel distributor and inspected the inlet screen. It was completely clean - no dirt or...