© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Hi all We have changed the clutch on a Ferrari 430. We have used a Texa tester for PIS self learning and clutch bleeding. With the tester we...
Very interesting reading. No wonder I have had such a hard time finding a SD 2. We have so far used a Bosch kts550 diagnostic tester on the cars,...
Hello. Thank you for your reply. The tester is for the company where I work. I have seen the tester on Ebay and think it is too expensive....
Hello all. I am looking for a SD 2 diagnostic tester. Does anyone know where I can purchase a SD 2? Regards Peter Hansen
Hello all. I have found out why the car could not start. The immobilizer was activated as assumed. So with the SD2 we were possible to reset...
Thank you all for your replies. I was surprised too, when I realised that there is an immobilizer in the car. I work with around 7 360ch cars and...
The car is in fact equipped with an immobilizer installed behind the driver seat. I have found out that this unit interfaces with the right hand...
Hello everyone - I am new to this forum and hope you can help me out with a start up issue. I have a problem with a 360 challenge. A dyno test...
I don't know if you refer to Ferrari part #106324 , also pictured in this post:...
Hello. I have a question regarding the speedometer signal generator for a 308 qv. I know this topic has been addressed several times on this...
Hello everyone. I'm looking for a crashed 360 Modena/Challenge for scrap use. It has to be a car with an undamaged front end. Is there aynone...
