Search Results | FerrariChat
Buy

Search Results

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

Search Again
Page 1 of 2
  1. Sheldon Rubin
    Post

    355 dash instrument light bulb type/no.?

    Are the miniature T1.5 warning light bulbs removed by lifting them up from the plastic sockets? Or are they soldered into the sockets? I have a...
    Post by: Sheldon Rubin, May 12, 2017 in forum: 348/355
  2. Sheldon Rubin
    Post

    Soft Top Wiring Diagram

    Thank-you for the above Thread Reference. I am going to see if I can disconnect the seat pot connector from underneath without removing the seat....
    Post by: Sheldon Rubin, Mar 5, 2017 in forum: 348/355
  3. Sheldon Rubin
    Thread

    Soft Top Wiring Diagram

    Does anyone have a Color-Coded Wiring Diagram for Standard Shift F355 Euro-Version if possible? Volume 3 of the Workshop Manual lists diagrams...
    Thread by: Sheldon Rubin, Mar 4, 2017, 2 replies, in forum: 348/355
  4. Sheldon Rubin
    Post

    Bleeding the clutch slave, how...

    I tried pressure bleeding and suction pump (MityVac) bleeding after the level in the clutch reservoir ran dry. Finally, I attached my small...
    Post by: Sheldon Rubin, Mar 28, 2011 in forum: Mondial
  5. Sheldon Rubin
    Post

    8 points distributor cap for QV?

    The Digiplex units are problematic and are becoming difficult to locate used. I also looked into alternative ignition systems when both of the...
    Post by: Sheldon Rubin, Mar 9, 2011 in forum: 308/328
  6. Sheldon Rubin
    Post

    Euro 1985 308 QV Exhaust Hot & Cold ?

    I first tried shaking out the pieces of the ceramic matrix that was described earlier in this thread. Then tried sucking them out with a vacuum...
    Post by: Sheldon Rubin, Oct 16, 2009 in forum: 308/328
  7. Sheldon Rubin
    Post

    Leatherique Dye Question Please

    An alternative is SEMs SHURE COAT (NOT Color Coat - which is for Vinyl and is also sold in spray cans). This is a water-based leather colorant...
    Post by: Sheldon Rubin, Sep 8, 2009 in forum: 308/328
  8. Sheldon Rubin
    Post

    Exh. Manif. Heat Shields needed?

    My car is also a '83 QV and the enclosed aluminum heat shields are falling apart and rattling badly. I have temporarily secured them with hose...
    Post by: Sheldon Rubin, Sep 8, 2009 in forum: 308/328
  9. Sheldon Rubin
    Post

    Is it possible to bench test the marelli digiplex ?

    Contact the Jose at the ECU Doctors in Florida. They post their repair services on eBay. They fixed both my Model 803As. Their Test Set-Up is...
    Post by: Sheldon Rubin, Sep 8, 2009 in forum: 308/328
  10. Sheldon Rubin
    Thread

    A/C Control Problem

    My '83 Mondial QV A/C blows cold and my heater works fine. Problem is that I cannot adjust the Temp Control to a setting that enables the...
    Thread by: Sheldon Rubin, Aug 28, 2009, 2 replies, in forum: 308/328
  11. Sheldon Rubin
    Post

    Removing CV Joints

    The Sears Craftsman Bolt Removal Set that you are referring to won't help remove the lock-nut when it is has the 17 mm head. One of the flats on...
    Post by: Sheldon Rubin, Jul 31, 2009 in forum: 308/328
  12. Sheldon Rubin
    Thread

    Removing CV Joints

    I had to replace the inner CV Boot (RH Side) on my '83 Mondial QV. This requires removing the half-shaft along with the CV Joints. Removing the...
    Thread by: Sheldon Rubin, Jul 31, 2009, 53 replies, in forum: 308/328
  13. Sheldon Rubin
    Post

    A/C Compressor testing service?

    Now that you have the compressor out of the car, you can run some simple functional tests. Rotate the shaft using a socket on the center bolt and...
    Post by: Sheldon Rubin, Jul 20, 2009 in forum: 308/328
  14. Sheldon Rubin
    Post

    How do i remove coil wire from distributor?

    Replacing the cable from coil to distributor with anything but a resistance wire can cause problems. I have recently experienced this with my...
    Post by: Sheldon Rubin, Jul 10, 2009 in forum: 308/328
  15. Sheldon Rubin
    Post

    Mondial QV Radio

    My 1983 Mondial QV has the original radio which is a Blaupunkt "Sacramento" AM/FM/Cassette. I never checked the make of the speakers in the...
    Post by: Sheldon Rubin, Jul 10, 2009 in forum: Mondial
  16. Sheldon Rubin
    Post

    WANTED: Digiplex Ignition Unit

    Thanks Rick for checking. ECU Doctors (Jose at 305-989-0724) were able to locate an 805A unit that they overhauled, bench tested, and even...
    Post by: Sheldon Rubin, Jun 12, 2009 in forum: 308/328
  17. Sheldon Rubin
    Post

    WANTED: Digiplex Ignition Unit

    Jon: Do you happen to know what the Electromotive Conversion Kit costs for the 308 QV?
    Post by: Sheldon Rubin, Jun 9, 2009 in forum: 308/328
  18. Sheldon Rubin
    Post

    WANTED: Digiplex Ignition Unit

    Thanks to all for the info, but I already sent the unit out to the ecudoctors.com in Florida. They do excellent repair work, however, my unit has...
    Post by: Sheldon Rubin, Jun 9, 2009 in forum: 308/328
  19. Sheldon Rubin
    Post

    WANTED: Digiplex Ignition Unit

    Thanks for the reply and let me know if they are the 805A units. You may contact me at [email protected] or at 914-937-6376.
    Post by: Sheldon Rubin, Jun 9, 2009 in forum: 308/328
  20. Sheldon Rubin
    Thread

    WANTED: Digiplex Ignition Unit

    One of my units in my '83 Mondial is defective and not repairable. I prefer a good unit, but will consider a bad one, i.e. a good core, if it can...
    Thread by: Sheldon Rubin, Jun 9, 2009, 10 replies, in forum: 308/328
Showing results 1 to 20 of 37 Next >
Search Again
Page 1 of 2