© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Here's how I held the sprocket on mine to allow removing and torquing of retainer bolt. I used the old belt and a piece of 1" square tubing....
Just put 4 new mounts in my 78 308. Piece of cake. I was surprised at how easy it was. I used a standard floor jack with a 2X2 block the...
The photos are a little deceiving. There is actually ample clearance between the wires and the carbs or anything else that the DFU's may be...
XDi is mounted on new plate in rear trunk directly in front of the driver side tail lights. Plate is attached with tail light ground screw and...
Plug wire separators came from local auto parts store. They are hot rod parts. Mounts were fab'd from sheet aluminum - drilled, bent, then edge...
I finished my Electromotive install a few weeks back and wanted to post some photos. I did this install without any mods to the car...no hole...
Just passed S.F. Bay Area smog with my '78 308. Had to re-core cats first though.
Birdman, No black available from this supplier. Just an aside, the silicone hose lining hose is prone to tearing if stretched too much. You are...
I did hoses on my '78 308GTS in all silicone a short while ago. Silicone Federal Hose in 1-5/8" diameter is available from Royal Brass &...
You are probably looking at the larger diameter counter bore drilling where the hollow alignment dowel used to be. These had two hollow dowels...
Looks like the scope is overlaying multiple ignition impulses on display. It is not possible to have multiple voltage traces in the same time...
What was Pertronix kit type that was used to make the mod to eliminate points? I am considering adding 4 Pertronix pick ups then using...