© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
do tell
I swear by Motul... very expensive but really shows its worth when you break an engine down and compare. The Challenge teams use it. I have a...
Take off the rear deck.. it will make things easy. Now you know what I was saying about spraying the hoses with silicone. It will make the job...
#58 [ATTACH]
# 58
I dont remember them being metal.. they are small rubber diameter of a dime... yes dont reuse them, get new ones for sure.. its cheap insurance a...
Great video my friend.. you got it.
Oh I did not tell you before you need to remove the ring buried on the grease after you pry off the end so that the boot slides out. You got the...
You will have to remove the metal part to get the boot out which will expose the entire bearing assembly... you should clean it all out. The old...
By the way the outer boots are not made to be replaced... when those go get new axle Use a towel or something to brace the clamp and crimp away...
Glad you decided to do it. Next time remove the axle bolt that goes through the knuckle... a lot easier than what that manual says. Also use a...
these are not split boots they are the real deal so you have to take it all apart and repack the bearings after cleaning. I will see if I can...
Squeeze them in your end and listen for air rushing out. You can do it with the engine in later but its much easier now. The kits are VW kits,...
Check your Transaxle boots closely they look a little larger than they should from the picture. This is a great time to address the issue if...
Break cleaner works great but yes need to worry about rubber parts. If used make sure you blow it dry with air just to make sure fluid does not...
While you have it out take time to clean everything... Your gearbox needs some loving ;-)
I put seal on it, but you may be right. The challenge car does have one section in the mated section that needs to be sealed... check closely...I...
I just read your question about the sealer material. Its a special white sealer ( I cant remember the name) I will get it for you, very thin...
I do not use treadlock of any of the nuts and bolts with the exception of break calipers or high speed parts such as transaxle. Someone else may...
Here it is, I love it also... what a work of art [ATTACH] [ATTACH]