© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Great, but is there any manual way to move the flaps up and down ?
The more I think about what lead to this issue, the more it points to the flap on driver side being physically jammed on its way down during the...
Thank you so much for the reply. Yes the engine cover closes completely but the flaps won’t go up and the sequence is then incomplete. So I try...
Side flaps won’t go up to complete down cycle and top won’t go up seems to block on up cycle. Any ideas?
So is it safe to say that the gap and tension frequency measured are only valid once engine is rotated two revolutions and a 2 min wait period has...
Installed new tensioners, updated bolts and bearings during cambelt change. Followed WSM to the letter and gap and tension are all within spec...
Thank you, just needed some reassurance
Every time I change belts I question the gap between the crank pulley and timing pulleys. I currently measure .042-.043”. Is this normal? It’s the...
Thank you Brian. Will try adjusting but I'm afraid the clearance to CV boot will be too small as it is now with both shields touching the cats and...
Thank you for the reply. I’m currently at 22 nm. Should I slack off a bit to 18 nm?
Is it normal that the CV boot heat shields touch the catalytic converters. It’s the same on both sides and drivers side seams to be deteriorating...
I have looked over the forum and on the net with no clear answer. The 360 manual calls for 75 nm tension on the exhaust flange spring bolts which...
P0050 - HO2S Heater Control Circuit Bank 2 Sensor 1 (Valid Code) P1198 - O2S Heater Circuit Bank 1 Sensor 2 Electrical Malfunction ( found on net...
I have codes P0050 and P1198 pop up instantly after clearing. Both come on at same time every time. The P0050 is HO2S Heater Control Circuit Bank...
Been doing it this way for 9 years. Never an issue and the most effective and intelligent way.
12" long 3/8 drill bit and elongated long nose pliers. Drill a little, remove a little til your done.
Takes more time, but you can drill them out and no cutting or welding required. I did it and job looks pro. I also removed insulation and shield...
When you say tensioners, you mean tensioner bearings or the tensioner bracket itself?
Anyone ever climb Mt. Washington, New Hampshire in their Ferrari? Is it recommended, or not?