© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
so you forgot to mark how the case was assembled before taking it apart. This picture should help. The cables exit the alternator closest to...
can you elaborate on that? afaik, the injection ecu can only control the frequency valve. That can modify the pressures internal to the fuel...
I just had my 328 glass replaced in california. Insurance here is a flat $100 copay, and doesn't affect your rates. total cost - around $5k....
fwiw, I drive a gts year-round in the san francisco bay area. No snow, of course, but rain and cold no problem. The top seals well. the...
I got some foam from a fabric place and some 6" polyolefin heat shrink tubing. the shrink tubing I used is a bit too rigid, so it was necessary...
since this wasn't in a thread you find with an obvious search.... I replaced the shift shaft seals on my 328 a few months ago. The biggest...
measuring the voltage proves there's no open circuit, but it doesn't test that there's no excess resistance in the circuit that will drop the...
ok, thanks! noise is most noticeable to me when the exhaust air injection check valves are flapping, and yup, it was louder after I removed the...
my foam is long gone....just have black duct tape around the core. was the original foam open cell or closed cell? I'm going to try polyolefin...
an old 1/4" drive socket of appropriate size (i.e. it can't get sucked into the plenum) inserted into the air hose restricts the flow nicely and...
update. Connecting the brown wire per the schematic results in the brake failure light illuminating (eventually) and loss of power braking....
while replacing the ignition switch on my '89 328 - intermittent fast battery drain caused by ABS relay/pump running when key removed - I dug up...
the gasket is not likely to separate cleanly. I replaced the shift shaft seals on my 328 a few months ago - which requires removing the oil...
anyone tried wrapping their original mesh core in foam and then using heat-shrink tubing over it? most shrink tubes top out at around 120-135...
an obscure place to look...if the washers on the top of the a/c compressor between the compressor case and the rubber mount aren't sandwiched in...
to more or less close the case on this... I contacted east coast jaguar to ask what they did to the pump in their rebuilds. What I wanted to...
an unexpected place to get hylomar universal blue - www.harborfreight.com - $4
hopefully some people can ring in and let me know how wrong the below is and fill in the gaps the original 328 pump used a 2-part seal (121533...
also suggest checking inside the coil secondaries for corrosion. A mirror or q-tip should do it.
about all you can do is make sure the connections are clean...short of carving the epoxy (or whatever it is) off the circuit board and seeing what...