© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Hi, I have what I believe you need. I sent you a P.M.
Thank you very much! I will call the guy tomorrow and, if he still has it, will go and take a look at it. I would like to restore this car and...
Hi, does anyone knows how to get in contact with this seller? I tried the # posted but it is not operational. I am not too far from it and...
Is the fuel accumulator the original one? That may be the cause. You could replace the pump and the accumulator at the same time and get that out...
Definately pull the engine. Take loads of pictures as they will come in handy upon re-installation. Make the engine look pretty before you put it...
I have this and it works perfectly. http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=94100 This probably work just as well...
I had a similar problem and replaced the flywheel sensors (all 3 but 2 were good) and it runs like a charm.
I use Evans coolant in my 308 GTSi without any issues. It can be run with a zero pressure radiator cap but it smells bad in my opinion.
Breda is a major Italian manufacturer of trains. Washington D.C. Metro trains are made by Breda (actually now they went to a Spanish firm)....
If you want to try your hand at welding , I would recomend to use MIG brazing. There are many good advantages over MIG welding such as much less...
Thanks to all! The car is a 1981 GTSi. I have the tank already disconnected and it seems it wants to come out but...it is tight. I have it...
Hi guys, I have a leak from the passenger side fulel tank. Do I need to remove the A arm or just the rotor in order for it to come out? Would...
I think that although new belts may be inexpensive why not repair the original yourself? The new webbing is readily available and stitching it is...
If it produdes a couple of inches it is normal. The window can not go down any further. I you need an exact measurament I will do that for you...
I received the 13152 alternator. It is identical to the original. The pulley has to be changed and it took 30 seconds. There are no markings on...
Well, I will try this again: http://www.partsamerica.com/ProductDetail.aspx?mfrcode=WWA&mfrpartnumber=13152&parttype=11&ptset=A
Hi, in the sticky thread about part sources, I found this. I just bought one but it has not arrived yet. It should be here tomorrow or the day...
I would tend to agree withGreg. That is a lot of movement. I would start checking from the rack up instead from the steering wheel down. Maybe the...
My belt was installed new when I did my engine-out service about 2-3 years ago. It did snap but just because it started wearing thinner and...
Hi, I just busted the water pump/alternator belt. It had been squealing and I did not re-tighten it therefore it failed. The WP bearings are...