© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I was out driving today,and i noticed on my heater control unit in the centre console,where the temperture read out is i got E8 and this stayed on...
pap 348, what size tyres are fitted to your 348, they look like 40 profile and what make are they
no,the ignition lights on the dash board batt/oil/etc. when i turn the key to start the car sometimes the ignition lights dont come on and the...
I think its a faulty ignition switch, if i turn the key backwards and forwards a few times, the ignition lights always come on and the car always...
thanks for the information guys
My ignition switch,when you turn the key to the start position,the ignition lights sometimes comes on and sometimes they dont.I've been told to...
i would like to fit some wheel spacers to my ferrari 348 ts 1990 rhd. to fill out the wheel arches ,does anyone know what sizes would fit
thanks for the information i will try it tomorrow phil.
the tail pipes on my exhaust are quite low they hang down about 75mm below the exhaust cutout on the body work,is their anyway to lift the pipes...
thanks for the information it was very much appreciated
my exhaust sounds like its rattling or vibrating when i rev the car could this be something loose inside the system or the brackets that support...
the roof leaks due to worn roof seals, does anyone know the best place to get these from. or is there other rubber seals that would do the job.
thanks everyone for your replies, especially phil haynes let you know when i decide to replace clutch. regards, phil. r
my ferrari is 1990 348 ts not sure if its single or twin plate clutch i think its twin, could i fit a single plate?, is there a way of telling...
not sure if its single or twin, will either fit, if not is there a way of telling how much is the single clutch kit. regards phil.r
is it possible to change the clutch by myself, if so where would be the best place to buy one from, for a reasonable price, i am pretty good with...
my 348 clutch is slipping, does this mean that the clutch needs replacing, or is thier some way of adjusting it also is there anything i can do...
How do you remove the bottom section of the dashboard , will it come off seperatly, to the top half off the dash.
how do you remove bottom section of the dashboard it looks like its connected to the top half but i cant see how it comes apart
is clutch slave seal easy to change i.e diy or garage job. also where is bleed point on clutch system. thanks phil.