© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Fantastic! Thanks.
Good Afternoon George Could you please send me the 599 wsm too? Email address: [email protected]
Lol Im going to try and make some time to finish this project. I still have everything in pieces. : (
no i haven't ernie... but i may have time this year to continue were i left off.
im the original owner of mine. Its a keeper for me. -daniel
I think the Lathe was $600. It is good for small metal parts. The Delrin was about $300. It was a winter project. Very pleased with the way the...
I did it a few years ago so cant remember what I did step by step but they do press apart... and come completely apart... those are the rears....
Also have a pic of when I did my bushings. I ended up buying a mini-lath and some delrin and made up all my bushings for the front and rear...
Dont replace the bearings... They can be re-greased. I did mine. The grease was all dried up... I cleaned them out and re-packed them and they are...
I had mine sent to Bilstein to get rebuilt. Very pleased and it was much cheeper then deltavee. They re-valved mine since I went with much...
^^^ yes, to get correct readings of your corner weights you must make sure you have no suspension bind. If you are using your hoist to lower the...
nobody has cc'd these heads on a rebuild? or porting job?
Does anyone have measurements or specs of combustion chamber cc of a stock 348 head? -daniel
very interesting... I am interested in knowing what is this adjustment shaft? The 348 shocks are not adjustable. Are you referring to the 355...
i shipped mine to Bilstein for rebuild. It was only $75 each and 3 to 4 weeks. http://www.bilsteinus.com/products/search-service/service.html...
"Tyre diameters are pretty close but are 10mm wider at the front and back" its not the width, its the height that matters. I agree, for its...
Thanks Flowed the exhaust side with 1mm larger valve and with OEM header. ........OEM (27mm)......28mm valve..... w/OEM header...
i tested my springs and they have gone soft and are below spec now. Are there good aftermarket springs available? Are there 348 aftermarket...
OK here is were it gets interesting... After a lot of work we now have 34mm large intake valves in the head. (thats 4mm larger then factory... I...