© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Stefan, Thanks for the reply. Any chance you can measure the part and let me know?
It has been ages since I have posted progress on 02956 but it doesn't mean that progress is not happening. The car is finally in paint and will...
Jon, This is also one of my favorite Ferrari designs. You are doing a magnificent job. Keep it up.
02956 was born in Nov 1971 and involved in a front end accident at mileage 11,816. The LH side of the nose had a circular depression indicating...
Freeman, Sorry, but I found one already. Thanks for the offer.
I am very confident that the body of 02956 is in good hands. There are still lots of parts that need attention and I am continuing to make...
Daryl, See pics attached for guts of unit. I tried to find new seals as well with no luck. The original ones are not too bad so I will reuse...
With the help of Alberto's experts, I was able to get a replacement for the under dash panel. This is the part that holds the wiring in place and...
Instead of working on the door inner frame, I decided to finish off the fiberglass bits. I started some time ago to replace the badly damaged...
The part that I ordered from Race Car Research is for the rear mounted "pressure limiting valve". This device biases brake pressure to the front...
Racerboy9, Thanks for the help. Parts are ordered. Regards, Jeff
I'm still looking for the small seals for the brake bias hydraulics....anyone? I've worked on the suspension off and on for a couple months and...
Worked on some smaller things over the week. The two small bobbins in the proportioning valve were badly corroded and so I made two new ones in...
OK, back to business. I found a couple different hand brake assemblies that I have in the shop for potential spare bits. They show that for Fiat...
I don't think that it is threaded....maybe splined. This appears to be one of the derivative Fiat hand brakes that was never meant to be...
Looks like I stumped the stars with the last post. I can't find any references showing the part so it looks like it will not be going on the...
I have pretty much completed all of the heater bits and will assemble as soon as I get the hardware plated. I did find a vent that I cannot find...
I am making progress slowly and surely. The damaged duct required more work than anticipated but the result was good. The shafts for both ducts...
Peter, I will attack in the order you recommended. I will go with mild steel....I may be able to salvage all but the straight tube. Brackets...
It did not go well. The shaft appears to be solidly welded to the square shaft. So, I split the tube and extracted the shaft and plate as an...