© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
My mother in law bought me a Halo Bolt years ago. I was highly dubious as most of those devices are usually dead when I need to use them. I...
Ferrari itself, in the not too distant future, will sell a car with a "slot car motor" Aaron
OH! A belt thread! Its been a while!
I had a few burned holes through extenders shortly after I bought my car. My poor mans solution was to wrap the holes with electrical tape and...
Saw a red 328 heading toward Llano this morning on 71. Great looking car! Aaron
Maybe in place of the original venting? Aaron
Ya! How many miles now?? 150k? Aaron
The part numbers are NOT the same between the 308 and 328 for the front shocks. I believe the part numbers for everything else though is the same...
288
No high beams? Are they just not needed because the LEDs light the road up further? I also have an MG and would consider this upgrade, but I...
20.75 x 1.75 inches
Hmmm, Im wondering if DS404 is the wrong part. Ive found several references to DS402 being the proper part. At least for the 308. And maybe...
Ive been working on replacing suspension components (OEM bushings, QA1 shocks, etc) and all has gone fairly smoothly until now. With all...
Along with the torque spec, Im not sure which way to put the bolt in that goes through the lower portion of the drop link. From the TAV it looks...
Im not sure what the torque specs for the nuts holding the drop link in place. I think I read that the lower nut is set to 7kgm. The workshop...
A little bit of heat did the trick. Once the bushing started moving it became much easier to get it the rest of the way out. Now I just have to...
I suppose the same can be applied to the steering ball joint, but with a small torque setting? thanks, Aaron
I have new my lower ball joints going into the 308. The old ones had a slotted nut with a pin to hold the nut in place. The new one came with a...
Im pretty sure the socket would fit inside the hole. It seems a bit smaller than the OD of the larger metal spacer. I would imagine these are...
I am trying to replace the metal encased rubber bushing that is inserted into the front droplink. I am having trouble getting the bushing out of...