© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Living in Uk, and using Superformance, I have never seen these long pipes on their site: they have asked me about a sample of the original alloy...
.......JUST WONDERING IF ANYONE HAD THE INFORMATION AS TO WATER PIPE LENGTHS....THOUGHT SOMEONE WOULD HAVE COME UP WITH AN ANSWER, OR HASN'T...
Could someone please measure for me the accurate overall length of these pipes - hopefully someone has car in pieces or old pipes to hand -...
My 1974 308GT4 has the usual problems with corroded and leaking "through chassis" water pipes. Whilst a temporary cure using flexible hose is in...
Check out the part numbers for both cars using Superformance or similar supplier sites. You could also e-mail the factory in Italy who are helpful...
If you have a 'mechanical' gauge which fits the dashboad I presume it is easy to change the dial by getting a picture from an original and then...
Well, I've passed my 80 and looking forward to the 308GT4 doing duty this summer. You are only as old as you feel......and I just had a drive in...
"TOFFEE NOSED"......SNIFF SNIFF.............
What we need is a list of parts used on Ferarri cars cross referenced to parts taken from the 'parts bin' of other makes, i.e. FIAT, or provided...
I needed to get to the clutch on my car so the ring nut on the drop gears had to come off (and go back on again) so a suitable size piece of...
This is a note for any fellow UK owners of the earlier Ferraris because you could be affected by the MOT emissions requirements, or be missing out...
Front Calipers on early 1975 308GT4. These are basically as used on some Porsche 911 models (suitably stretched with spacer) and seems originally...
I'm in the same situation.......early 308GT4 which has a gauge reading very low especially when hot. Previous owner had engine stripped but...
Please did anyone manage to find details of a replacement substitute part for the OIL PRESSURE SENDER UNIT used on early (4 x weber carburetted)...
Please could someone tell me the correct t.p.i. for the oil pressure sender unit originally fitted? I am told there is an inexpensive...
Forgot to note that any clarification etc., can be made by contacting me on [email protected]
Not sure whether there was any reference to the badges for the centre of the "DINO" hubcaps - these are 50mm, whereas I think those for the 206...