© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
The car has 12,500 miles. Believe it or not they all flowed pretty well from the get go. Only two flowed slightly less, but were fixed with...
Sunday I rebuilt/tested the injectors.. Had to fix my Chinese injector cleaner. It's not the best made machine, but it gets the job done....
So.. I had a weekend of disassembly since I am waiting on parts -Pulled the pedal box -Removed the intake(makes it a lot easier to do the valve...
It's kind of par for the course... The throttle bodies were loose, I easily just pulled one off. The valve covers were leaking(I found this...
Things may have spiraled a bit.. Typical bring a trailer purchase. [ATTACH]
Also, removed the K40 radar. The Ferrari dealer did an awful job installing it. They had double sided taped it to the back of the dead pedal and...
Cleaned up the tunnel. Might be a tad over the top, but may as well do it while its out. [ATTACH]
I agree, I have never seen a maf knockoff work correctly.
Thanks for clarifying the flywheel position, I didn't see the smaller bolts when pulling it off. Great info! My only suggestion for the slave...
Removed the center console. The factory manual is pretty good, besides removal of the center carpet. There's two screws in the bottom back of...
You need to pull the trans so that you can at minimum replace the seals on the throughout bearing and modify the trans tunnel heat shield.
Things went down hill when working on the slave cylinder. I had bought a new Hill T/O bearing. It does not worth with F1 Flange. The guide...
Removed the clutch and flywheel. I packaged it all up and sent it out for a rebuild. Top Tips: The flywheel only goes on in one direction....
Installed the selector. Used Reinzosil, as it's rated for gear oil. Removed the studs that were no longer used. Replaced the studs with two...
Next I removed the shifter mechanism. Just remove the m6 nuts and it pops out as an entire mechanism. Make sure you mark and take picture of the...
Removing the bell housing... You need to disconnect the clutch sensor. There's a red wire that goes up through the engine bay, under the...
After removing the exhaust, it's time to pull the trans. This is documented in the service manual, but here are yet again... Adam's Top Tips:...
Removed the exhaust. Adams Top Tips:) - Remove the over axle pipes, as it'll give you more room for moving the axles out of the way when pushing...
I have started the conversion. 1. I removed the f1 actuators, and all the lines from the transmission. I'll clean up the left over wires later....
