© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Do you know if the boots are the same on 348 and 355? They sure look very similar... (A can only find boots for 355 on ricambiamerica) Peter
I fully agree! I will update this thread in a month or so when I have removed the axle. Since Ferrari sells an outer boot ($250) it should...
Arghhhh, it is the other one (where the 8 is). Still Ferrari wanted to sell me that boot (and they checked the correct model, since I had to give...
Hmm strange, I got the price of the boot from a Ferrari mechanics repair shop. And it was just the boot (even if it was expensive). Here is a...
Ernie, did you buy the original boots?
Thanks, I will check that boot. It is a 108mm CV joint on the 348 so it should fit. Question: Do I have to remove inner boot from its position...
No...that is just for the boot! Do you remember where you bought your boots? Or even better, what Porsche uses the same dimensions of the boot?
I finally got an answer from the Ferrari dealer: The cost for one boot: $250 ... incredible...
So I have to remove the complete drive shaft to get the boot of? Are there any loose parts that will fall out or that are difficult to remount or...
How is this done? Is this an 'easy' job that you can do yourself? Do you buy the new boot from Ferrari or is it a standard part that can be...
Actually I tried turning the perch in both direction, didn't work. I will try some heat, if that doesn't work, I will leave it for a couple of...
I actually removed the preload from the spring by 'clamping' the spring. I still did not manage to turn the platform. I used a lot!!! of force....
How do I loosen the 'big' aluminum perch without destroying the 'soft' aluminum? The locking nut was not a problem.
yes, the one with the jumping cam belt :-( Anyway, now it is fixed and the car is back on the road :-)
Nice picture...again :-) Lukas, where in Sweden do you live? Myself...in the Malmo region.
Thanks! Connector checked. There is none :-) They must have changed this during the years (I have a -93 348 Euro)
Is there a connector like this also on the 348? I might have the same problem, but I cannot find the connector you are reffering to...
airbarton: Is it the 12 pin connector you are reffering to (up to the left)? I tried to follow the ignition wire (hard...) and I think it ended...
Still have not found that Gremlin ;-) So at the moment the car works fine! so I have not been able to measure the power when the starter is...
I have started the car a couple of times using a wire between the "+" and the connection point that activates the solenoid (same as coming from...