© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
It is going up on the lift tomorrow. Hopefully the set screw on the adjustment knob backed off and the knob is just spinning and it is set at the...
Just installed qa-1 on my 81 gtsi. The install was no problem, but I lost one of Verells bushing so I had to make one. I did the steering rack a...
Thanks for the help. I am going to silicone it first and see what happens. I went to a rim and tire place and saw a rim there, it had silicone on...
My front rim is leaking around the bolts that hold it together. How or were do I get them fixed. I dont know anthing about them why are they made...
sorry , 81
I have a 81 also and my dizzy leaks too. I have replaced the seals and gasket. I have a little metal plug at the end of the shaft under the rotor...
The part number for the injector seal Bosch# 3430210606 is that wright? I have new o-rings and injectors i just need seals. Any good source for...
I am doing mine this week. I have the poor hot start problem. It starts up right away cold and I have to give it 1 inch of pedal to start when...
I am right over the board in N.Y. I have a 2v I do most of the work myself. I have had mine 16 months now and love every minute. This time of...
My em brake does not work it is do to the spring on the caliper is broken. Does anyone know were to get one. I realy need it to get threw...
Do you have the contact info for them I need injectors and seals also thanks jim
My car is a 81 gtsi. thanks for the info. What about springs would you recommend for a car that is not a track car but is driven pretty hard. I...
I want to put new shocks in the car and have read about the qa-1 shocks here. Are guys using them because they are better or less expensive then...
Thanks for help all fixed. Bad ground for head light and horn button was not making contact with steering wheel housing. thanks jim
I have a 81 gtsi with some electric problems. I replaced fuseblocks a few months ago with Birdmans. They look and work great.There has been some...
I have a oil leak coming from my distibutor for some time. I have replaced gasket and cam seal still a leak. There is a small metal plug at the...
I have a problem with warm start starts also, starts cold fine and a warm start I need to give a inch of peddle to start. Sound like I need a new...
Yes that is it. The pin is in there very tight. I was thinking about some heat to expand the metal but then the o-ring would be melted If i could...
the o ring on the cam shaft by the distributor. thanks jim
I dont even see the o ring is that normal? i would try that cut method i have done something similiar. thanks jim